扭转角的英文
angle of distortion
angle of thread
angle of torque
angle of torsion (angle of twist ）
+更多解释...
例句与用法
更多例句： 上一页 - The principal axis torsion angle , produced by torque , is converted to two channel square waves with phase difference through grating sensor . then the degree of torsion angle is measured by data collection card . finally the value of torque and the other parameters of the axis can be calculated by upper pc
将主轴受扭矩作用而产生的扭转角，通过光栅传感器转换为两路有相位差的方波信号，再通过数据采集系统检测出扭转角的度数，最后由上位pc机计算出扭矩的大小和主轴的各种参量。 - The whole building can be equivalent to a cantilever bar , and the structural total displacements can be divided into parallel displacement and rotational displacement based on the harmonize condition of displacement , and the parallel shear and the rotational shear of the elements can be accordingly obtained by selecting the renegade body from top to bottom in turn
根据位移协调条件，将结构的位移分解成平动与转动成分，得到相应的结构平动时构件所承担的剪力与结构转动时构件所承担的剪力，再根据力的平衡条件，推导出双向地震作用下考虑构件抗扭刚度时结构的线弹性扭转角，并对构件的剪力及变形进行了修正。 - Referring to three kinds of plan irregularity , structures individually with four kinds of irregularity as eccentricity in one direction , eccentricities in two directions , re - entrant corner irregularity and diaphragm discontinuity have been analyzed to investigate the relationship between torsion effects and parameters of above irregular structures . the parameters and the schemes for determining the scope of structures with different kind of irregularity considering seismic action in two directions simultaneously are proposed , some conclusions have been get as following : it is indicated by the analysis results that torsion effect has no dependency relation with eccentric torsional angel adopted in code for seismic design for buildings . it is suggested that the eccentric torsional angel should not be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricity in one direction due to irregular mass layout , the relative eccentricity can be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricities in two directions due to irregular mass layout , the ratio of relative eccentricities in two directions and the angel of them can be take as the parameters of torsion effect of structures considering seismic action in two directions simultaneously ; it is indicated by the analysis results that the torsion effect has no dependency relation with re - entrant corner ratio adopted in code for seismic design for buildings as
所取得的主要结论有：结构的扭转效应与《抗震规范》所采用的扭转不规则指标即偏心扭转角之间的相关性较差，偏心扭转角不宜作为判断结构是否计及扭转效应及需考虑双向水平地震作用的界定指标；对于楼层间均匀偏心的多层单向偏心结构，建议采用相对偏心距作为需考虑双向水平地震作用的界定指标，并给出针对不同平面尺寸的界限相对偏心距；对于楼层间均匀偏心的多层双向偏心结构，建议采用两个主轴方向的相对偏心距及其夹角作为界定指标，结合单向偏心结构的界定方案进行需考虑双向水平地震作用的结构范围界定；凸凹不规则结构的扭转效应与凸凹比例无正相关关系， 《抗震规范》要求所有平面布置不对称的凸凹不规则结构计及扭转效应的规定欠妥当，建议凸凹不规则界限值从30改为15 ，只要求分析采用空间模型比较合适； 《抗震规范》关于有效楼板宽度较小的结构需计及扭转效应的规定很有必要，楼板局部不连续的结构需采用符合楼板实际刚度的计算模型予以分析，可使用相对偏心距（及其夹角）参照单向（和双向）偏心结构的界定方案，界定楼板局部不连续结构是否需要计入双向水平地震作用下的扭转效应。 - Lastly , previous vane are analysed by fluent , we calculate the pressure distribution chart and report chart of each wing form , then alter the torsion angle and the airfoil form of the vane respectively , finally ascertain the influence curve of the torsion angle and the airfoil form of the vane on which act the lift power
最后,通过fluent对设计出的叶片分析,得出其压力分布图和报告图。然后从改变叶片的扭转角度和翼型两个方面分析其对升力和阻力的影响。得出叶片的扭转角和翼型对升阻比的影响曲线,在文章的结尾部分估算了无人机的一些性能参数。
