rail-to-rail中文是什么意思

• 轨至轨
• 线对线

• "rail"中文翻译    vi. 咒骂，责备；抱怨 (against at)。
• "on rail" 中文翻译 :    铁路交货; 已装火车上
• "rail" 中文翻译 :    n. 1.(围栏等的)横木，横档；(钉帽架等用的)横条，栏杆，扶手；〔pl.〕围栏。 2.轨道；钢轨；铁路；〔pl.〕铁路股票。 a towel rail (钉在墙上的)挂毛巾的横木。 a rail advice (铁路)到货通知单。 zero-length rail 【火箭】超短型导轨。 by rail 乘火车，用火车。 get [go] off the rails 出轨；越轨。 off the rails 出轨；扰乱秩序；〔比喻〕发狂；越轨 ( He is a very reliable person he has never gone off the rails. 他这人十分可靠，从来不越轨逾矩)。 ride (sb.) on a rail 〔美国〕(把人)捆在横杆上抬着赶走〔一种私刑〕。 run off the rails 出轨，脱轨。 vt. 1.用围栏围 (in off), 用栏杆围住，装栏杆于。 2.在…铺铁轨；用铁路运输。 vi. 坐火车旅行。 n. 【动物；动物学】秧鸡。 vi. 咒骂，责备；抱怨 (against at)。
• "rail in" 中文翻译 :    用栏杆围住
• "t rail" 中文翻译 :    骨牵引用 t型横档
• "rail to rail" 中文翻译 :    舷到舷
• "cant of rail rail" 中文翻译 :    cant轨底坡
• "hand rail (or open rail)" 中文翻译 :    栏杆,扶手
• "keel rail (or bilge rail)" 中文翻译 :    救生艇底扶手
• "rail bubble rail corrosion" 中文翻译 :    钢轨锈蚀
• "rail clamp; rail clip" 中文翻译 :    轨夹
• "rail crack rail crackes" 中文翻译 :    钢轨裂纹
• "accessories of rail" 中文翻译 :    钢轨附件
• "accommodation rail" 中文翻译 :    栏杆扶手栏杆装置; 舷栏杆
• "altar rail" 中文翻译 :    围绕祭坛之栏杆
• "anchoring rail" 中文翻译 :    锚固槽钢
• "apiral rail" 中文翻译 :    螺旋性发射导轨
• "arch rail" 中文翻译 :    拱形铁轨
• "arris rail" 中文翻译 :    三角【断面】横档; 三角轨; 三角栏杆
• "arrish rail" 中文翻译 :    三角拉杆
• "austral rail" 中文翻译 :    南秧鸡
• "baby rail" 中文翻译 :    小钢轨
• "bamboo rail" 中文翻译 :    推拉门用竹制轨槽
• "bar rail" 中文翻译 :    钢条轨
• "barred rail" 中文翻译 :    横斑秧鸡

• The sgm8067 is rail - to - rail output voltage feedback amplifiers offering ease of use
  Sgm8067是轨到轨输出电压反馈运算放大器。
• The new rail - to - rail low - voltage op - amp can be applied in dvd player , sound card , cellphone , gps system and so on
  这种新型的轨对轨低压运放可以用于dvd播放器、声卡、手机、 gps系统等电路。
• The lower supply also makes the dynamic range of signal reduced . this requires the op - amp a rail - to - rail input and output stage
  电源电压的降低也使得信号的动态范围极大减小，这就要求运算放大器能做到输入轨对轨和输出轨对轨。
• Third , rail - to - rail amplifier output stages exhibit load - dependent gain which affects amplifier open - loop gain , and hence closed - loop gain accuracy
  第三，轨到轨放大器输出级增益与负载有关，这将影响放大器的开环增益,当然也影响了闭环增益的准确性。
• 3 . the output stage of transimpedance amplifier is realized with rail - to - rail topology to meet the requirement of output swing of the instrumentation amplifier
  3 .针对仪表放大器的输出摆幅的要求,在跨阻放大器的输出级采用rail - to - rail结构来实现。
• In this thesis , analysed and designed the architecture of the new type cmos rail - to - rail operational amplifiers in detail , and successfully designed one of two stage compact cmos rail - to - rail amplifier and the cmos bandgap reference current source
  本次论文详尽地分析和研究了新型cmosrail - to - rail运算放大器的结构，完成了两级压缩式cmosrail - to - rail运算放大器和cmos带隙参考电流源电路的设计。
• In order to expand the signal the dynamirange , the low voltage operational amplifier usually needs the input signal scope and the output signal scope to be able to achieve the entire amplitude , in view of this question , this article discusses as follows : one is designed with ab rail - to - rail output stage
  为了扩大信号的动态范围,低电压运放通常需要输入输出的信号范围能达到全摆幅。针对这个问题,本文做了如下工作: 1 )设计了一个是包含ab类轨对轨输出级的低功耗运算放大器。
• The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power , and analyzes the principles of work , merts and shortcomings of these technologies , based on the absorption of these technologies , it designs a 1 . 5v low power rail - to - rail cmos operational amplifier . when designing input stage , in order to enable the input common mode voltage range to achieve rail - to - rail , it does not use the traditional differential input pair , but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure , and uses the proportional current mirror technology to realize the constant transconductance of input stage . in the middle gain stage design , the current mirror load does not use the traditional standard cascode structure , but uses the low voltage , wide - swing casecode structure which is suitable to work in low voltage . when designing output stage , in order to enhance the efficiency , it uses the push - pull common source stage amplifier as the output stage , the output voltage swing basically reached rail - to - rail . the thesis changes the design of the traditional normal source based on the operational amplifier , uses the differential amplifier with current mirror load to design a normal current source . the normal current source provides the stable bias current and the bias voltage to the operational amplifier , so the stability of operational amplifier is guaranteed . the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier
  本论文对国内外的模拟低电压低功耗技术做了广泛的调查研究,分析了这些技术的工作原理和优缺点,在吸收这些技术成果基础上设计了一个1 . 5v低功耗轨至轨cmos运算放大器。在设计输入级时,为了使输入共模电压范围达到轨至轨,不是采用传统的差动输入结构,而是采用了nmos管和pmos管并联的互补差动输入对结构,并采用成比例的电流镜技术实现了输入级跨导的恒定;在中间增益级设计中,电流镜负载并不是采用传统的标准共源共栅结构,而是采用了适合在低压工作的低压宽摆幅共源共栅结构;在输出级设计时,为了提高效率,采用了推挽共源级放大器作为输出级,输出电压摆幅基本上达到了轨至轨;本论文改变传统基准源基于运放的设计,采用了带电流镜负载的差分放大器设计了一个基准电流源,给运放提供稳定的偏置电流和偏置电压,保证了运放的稳定性;并采用了带调零电阻的密勒补偿技术对运放进行频率补偿。
• The other is the design of amplifier with constant trans - conductance ( gm ) rail - to - rail input stage . when common mode input voltage changes , it provides nearly constant - gm independent of input transistor operating region ( strong , moderate or weak inversion ) , and the quiet nods of the circuit for current addition and the output stage keep unchanged
  当输入共模电压变化时,不管它的输入mos差分对管处于强反型区还是弱反型区,输入级的跨度保持不变,而且输入级后面的电流加法电路和输出级的静态工作点也不会随之改变。