Based on the relationship between the temperature value , conglutination value and the amount in the turpentine , the temperature value and the conglutination value were selected being the direct measuring values . through these two values , the amount of terebinth was measured indirectly . and a new way to measure the conglutination value on line was brought foreword 分析了澄清阶段澄清脂液的物性特点，找出了脂液温度、粘度和含油量大小之间有内在联系，采用温度与粘度这两个较易实现在线检测的量作为直接测量的变量，然后通过这两个变量来间接检测含油量的大小。
The research results show that aggregate gradation and the nominal maximum aggregate size evidently influence the shear resistance of asphalt mixture ; aggregate flakiness content influences the shear resistance of asphalt mixture , and with the increase of aggregate flakiness content the shear resistance of asphalt mixture decreases ; asphalt binder properties , especially penetration , softening point and viscosity influence the shear resistance of asphalt mixture , and the latter increases with the decrease of penetration and the increase of softening point and viscosity ; asphalt content influences shear resistance of asphalt mixture , and with the increase of binder / aggregate ratio the shear resistance of asphalt mixture decreases ; air void influences shear resistance of asphalt mixture , and usually with the increase of air void the shear resistance of asphalt mixture decreases ; homogeneity does not have a direct and obvious relationship with absolute value of shear resistance of asphalt mixture , but does with variation of shear resistance of asphalt mixture 研究结果表明：集料级配和公称最大集料粒径对沥青混合料抗剪强度有显著的影响；沥青混合料抗剪强度受其集料中针片状含量的影响较大，集料中针片状含量增大，沥青混合料抗剪强度减小；结合料的性质，特别是针入度、软化点和粘度对沥青混合料抗剪强度有较大的影响，随着针入度减小，软化点和粘度增大，沥青混合料抗剪强度增大；含油量对沥青混合料抗剪强度有较大影响，随着油石比的增大，沥青混合料抗剪强度减小；沥青混合料抗剪强度受其空隙率的影响较大，一般随着空隙率的增大，其抗剪强度减小；沥青混合料均匀性与沥青混合料抗剪强度绝对数值间没有明显的关联，而与数值间的变异性有着很好的相关性。
The specific methods : 1 . to ascertain five control indications including suspended solid content , grain diameter median , oil content , iron bacteria and saprophytic bacteria by carrying out the experiment of core flow ; 2 . to ascertain indications of sulfate reducing bacteria and average corrosion rate by carrying out the experiment of revolving corroded test pieces ; 3 . to ascertain indications of average scaling rate and total mineralization degree by carrying out the experiment of scaling prediction and sensibility 具体的做法是：采用岩心流动试验确定悬浮固体含量、颗粒直径中值、含油量、铁细菌和腐生菌五项控制指标；采用旋转腐蚀挂片实验确定硫酸盐还原菌和平均腐蚀率指标；采用结垢预测和敏感性实验确定平均结垢率和总矿化度指标。
