开启位置的英文

• enable position
• open position
• open site

• "开启"英文翻译    open
• "位置"英文翻译    seat; place; location; site
• "断开位置；开启位置" 英文翻译 :    open position
• "锁定在开启位置的装置" 英文翻译 :    lockopen device
• "销钉固定的开启位置" 英文翻译 :    pinned open position
• "开启" 英文翻译 :    open 自动开启 open automatically
• "打开，开启" 英文翻译 :    open
• "接通, 开启" 英文翻译 :    turn-on
• "接通，开启" 英文翻译 :    switch on; turn on
• "开口；开启" 英文翻译 :    opening
• "开启；开创" 英文翻译 :    open up
• "开启；开路" 英文翻译 :    open
• "开启的" 英文翻译 :    unenclosed
• "开启杆" 英文翻译 :    all or nothing piece; all-or-nothing piece; easing lever
• "开启力" 英文翻译 :    breakaway force
• "开启桥" 英文翻译 :    balance bridge; movable bridge
• "开启式" 英文翻译 :    open type; open-type
• "轴开启" 英文翻译 :    axis on
• "开启者；开启工具" 英文翻译 :    opener
• "位置" 英文翻译 :    1.(所在或占的地方) seat; place; location; site 大家都按指定的位置坐了下来。 everybody took their places.2.(地位) place; position 她曾是个在政府中占有重要位置的女人。 she was a woman of high position in the government.3.[航] position
• "按键开启" 英文翻译 :    press switch to open
• "暗室开启" 英文翻译 :    open in dark room
• "不得开启" 英文翻译 :    the tenderer shall sign and keethe bid documents when receiving and may not open them
• "常开启接点" 英文翻译 :    normally opened contact
• "车门开启" 英文翻译 :    door open

• The pcv valve sticks in the open, maximum-flow position .
  把PCV阀固定在开启位置即最大流量位置。
• The pcv valve sticks in the open , maximum - flow position
  把pcv阀固定在开启位置即最大流量位置。
• Set handle in open position
  将手柄调整到开启位置。
• If the valve is too large , the disc will float in a partially open position and may cause fluttering of the disc and rapid wear
  如果阀门太大，则阀瓣浮动只能达到部分开启位置，并且可能导致阀瓣的振动和迅速磨损。
• The valve stem is not connected to the disc , and when the stem is in the open position then the disc is free to respond to the flow
  这种阀的阀杆并不连接到阀瓣上，当阀杆处于开启位置时，阀瓣可以根据流体流向自动进行调节。
• Disc stop ? provides positive stop in open position ; positions disc to effectively function in either horizontal or vertical ( flow - up ) pipe runs
  阀瓣止回-在开启位置提供积极的止回功能；位置阀瓣在水平或垂直(流向朝上)管道的功能明显。
• Once correct flow rate setting has been established , slide memory stop clockwise towards open side of indicator plate until memory stop ring hits indicator plate
  一旦确定正确的流量设置，则将记忆止动装置朝着指示器板的开启位置顺时针方向旋转，直到记忆止动环触到指示器板为止。
• Mixture mixing : install and debug the mixing equipment before construction , take the trial mix according to the mixture ratio , and find out the turning on location of every hopper strobe as well as the relation among material flow of every kind , draw up the curve , and if there is adjustment because of factors like material batch , difference of moisture content and so on , it need to be confirmed by the laboratory so as to ensure the mixture ratio of construction meet the design requirement
  混合料拌和：施工前首先安装、调试好拌和设备，根据确定的配合比进行试拌，找出各料斗闸门开启位置与各种材料流量的关系，并绘制成曲线，如因材料批次、含水量不同等因素而调整,须由试验室确定，以确保施工配合比符合设计要求。
• By measuring the differential pressure and using a regulated valve position to balance the flow rate to the same % dfr as the index valve , the next most favored branch can then be proportionally balanced as above and so on - finally after all the branches have been proportionally balanced the branch valves can then be proportionally balanced to each other
  通过测量压差和使用一个将流动速率平衡到与指标阀相同的% dfr的已经调节开启位置的阀门，次容易分支随后也可以合上述过程一样被比例平衡，等等-最后，在所有分支都被比例平衡之后，分支阀门随后也可以互相比例平衡。