girder造句

• A test load was applied to the girder .
  一个试验载荷作用于该梁上。
• The longitudinal girder forms part of the parapets .
  纵梁成为栏杆的一部分。
• The main girders support i-section transverse ribs .
  主梁支承着工字梁的横向肋。
• Most often this involved a segment of a girder web .
  大多数出现在主渠腹板部分。
• The girder is braced against an erection bracket .
  梁支撑在塔柱上的一个施工托架上。
• The cross girder center segments of the bents were field bolted .
  构架横梁的中间段在工地用螺栓连接。
• Termination of the cables is at a height of 1/6 the span above the girders .
  索端在梁以上的高度为16跨长。
• Compatibility will require that the girder deflection at b be zero .
  根据协调性的要求，梁在B点的挠度应为零。
• All girders shipped by rail were arranged on a flatbed rail car .
  由火车装运的所有主梁都安放在平板火车车皮上。
• The web and flanges of the main girders were fabricated from astm a441 steel .
  主梁的腹板和翼缘用ASTMA441钢制造。
• In the tie girder boxes crack growth was detected near the crack tip .
  在系杆箱型梁中裂纹尖端附近检测到裂纹的扩展。
• This span, which is larger than the clear span, is used in the design of the girders .
  这种跨度用于大梁设计中，它大于净跨。
• Each bundle of strands is connected to one side of the center web of the two cell box girder .
  每束钢缆锚固在双箱梁的中间腹板的一侧。
• During fabrication slots for the stringers flanges were flame cut into box girders .
  制造时，为安装纵梁翼缘，在箱型梁中用焰割法开槽口。
• The successful alternative was the cast-in-place segmental prestressed concrete box girder .
  最后采用的方案是分段现浇的预应力混凝土箱形梁。
• The scheme is a transition between the box girder with vertical piers and the true arch .
  该结构是具有垂直墩的箱梁桥钢与真正的拱桥之间的一种过渡形式。
• These structures were usually skewed with the diaphragms placed perpendicular to the longitudinal girders .
  这些结构通常是斜交的，而横隔板则垂直于纵梁布置。
• The variable-depth girder is 4. 96m deep at the piers and 1. 83m deep at midspan and its extremities .
  梁高是变化的，在桥墩处为4.96米，在跨中和端部为1.83米。
• Often lack of fusion adjacent to the girder web in the transverse groove welds led to the cracking .
  在靠近主梁腹板的横向坡口焊缝处常常出现未熔透而导致裂纹。
• The box girders were to be precast units, bonded together in place at the joints with an epoxy resin .
  箱梁采用预制构件，在现场连接处涂以环氧树脂，以粘结成为整体。