overtightened造句

• If the nut is overtightened the ferrule will deform improperly causing the joint to fail.
• The port line was overtightened as it was connected to the post of the ground winch.
• If this bolt is overtightened, it can easily dimple or " drill " into the batten seriously compromising the strength of the batten.
• The washers will deteriorate with exposure to hard water or if the stem is overtightened, but replacement washers are cheap and easy to replace.
• "People may have the feeling the law should be tightened, but they don't want it overtightened, " he said.
• Some critics have charged that the Fed overtightened and greatly increased chances of a downturn in the world's biggest economy this year or next.
• "I think the Fed probably overtightened in 1994 and early 1995, " said Larry Chimerine, managing director at the Economic Strategy Institute.
• A loose belt will slip ( usually accompanied by a high-pitched squeal ), and a belt that has been overtightened will cause premature water pump failure.
• Overtightened wheel nuts can be a problem, too, because they can twist the shanks of the wheel studs they screw onto, weakening them to the point of breakage.
• When Irish tenor Joe Feeney on " The Lawrence Welk Show " reached for high notes, he sounded as if someone had just overtightened a screw in his back.
• The ligature must be placed at least halfway down the stock of the reed and the screws must not be overtightened, in order to allow free vibration and not distort the reed.
• The report also indicated that whilst one of the bolts was missing, the other was broken and had damaged threads commensurate with being overtightened or jammed, which twisted the head off, or came close to doing so.
• On board, people heard a muffled detonation and those in the front of the ship felt a shock as the port trail rope overtightened; the officers in the control car initially thought the shock was caused by a broken rope.
• There is a very high degree of torque applicable when one of the " perfect fit " drivers is required, and for the same screw thread in the same condition of rusted or overtightened, the straight or phillips would be likely to slip out and mangle the head of the screw.