主气流的英文

• main airflow
• primary air

• "主"英文翻译    host
• "气流"英文翻译    air current; airflow; wind c ...
• "主气" 英文翻译 :    host climatic qi
• "肺主气" 英文翻译 :    lun governing qi; lung controlling respiration
• "主气阀" 英文翻译 :    main air valve
• "主气门" 英文翻译 :    main stop valve; main throttle valve
• "主气旋" 英文翻译 :    primary cyclone
• "主气垫管道" 英文翻译 :    main cushion duct
• "主气缸活塞" 英文翻译 :    master cylinder piston
• "气流" 英文翻译 :    1.[气象学] air current; airflow; wind current; airstream2.[语言学] breath◇气流纺纱 open-end spinning; break spinning; 气流纺纱机 open-end spinning frame; 气流干扰 interference in air flow; 气流畸变 flow distortion; 气流计 airometer; anemometer
• "暑为季的主气" 英文翻译 :    summer-heat prevails in summer
• "主气动试验间" 英文翻译 :    aero cathedral
• "主气体动力平衡" 英文翻译 :    main aerodynamic balance
• "气流, 气流量" 英文翻译 :    gas flow
• "气流；气流量" 英文翻译 :    airflow
• "气流空气流" 英文翻译 :    airstream
• "氨气流" 英文翻译 :    ammoniakgasstrom
• "爆炸（气流）" 英文翻译 :    blast
• "侧气流" 英文翻译 :    sidewind
• "掺气流" 英文翻译 :    aerated flow
• "充气流" 英文翻译 :    vented flow
• "大气流" 英文翻译 :    atmospheric current
• "电气流" 英文翻译 :    electric souffle
• "肺气流" 英文翻译 :    pulmonary air flow
• "废气流" 英文翻译 :    exhaust flow; exhaust gas stream

• The diffuser length should be long enough to ensure the main flow deceleration
  扩压段应具有一定的长度以保证主气流减速到一定程度。
• The asu manufacturing process begins with a main air compressor and ends at the output of the product storage tanks
  Asu生产过程从一个主气流压缩机开始，产品储存罐的输出后结束。
• The configuration of the diffuser should be designed as a channel to allow the main flow pass through a shock train
  扩压段的形状应设计成能使主气流通过系列斜激波串减速的通道。
• A few layers of temperature measuring nets was fixed in the furnace in the test - bed . the distribution of the concentration of diffenent temperature air was gotten through measuring the distribution of the temperature in the furnace . finally , the mixture situation in reburning area and burnout area were gotten totally
  即主气流和燃尽风采用室温气流，再燃天然气采用高温空气模拟，在炉内布置多层测温网络，通过测量炉内温度场的方法获得炉内再燃风、燃尽风及主气流的混合浓度场，从而定量反映出炉内再燃区及燃尽区的混合情况。
• Different disposal style for the reburning air & burning out air ( tangential or front and rear walls ) and their disposal heights . 2 . different momentums of ofa ( under the condition of constant airflow of primary area and condition of constant flux inputted simulated boiler )
  冷模试验范围包括： 1 、再燃风和燃尽风的不同布置方式（切向布置和对墙布置） 、布置高度； 2 、不同燃尽风动量（炉内总进风量不变和燃烧器主气流不变两种情况） ； 3 、再燃风、燃尽风的不同组合与主气流之间的混合。
• And then , in the simulation of three - dimensional , the application of o - type grid and hybrid grid are used in two relatively complicated structures make the total amounts of grids and the time of grid generation reduced greatly . moreover the hexahedron grids are placed in most areas to provide higher precision . through the comparison between the results of two - dimensional and three - dimensional simulation , we knew two - dimensional calculating is not adequate
  本文用简单、方便的二维模型作为数值计算的起点，使用耦合隐式算法以及先进的v2f湍流模型进行求解，成功地捕捉到了激波，观察到主气流从壁面的分离、切换、再附壁等现象，并对计算结果进行了细致的分析，得出一些有意义的结论；在此基础上，本文在国内外首次对超音速射流双稳阀的三维流场进行了计算。