作用参数的英文

• operational factors

• "作用"英文翻译    act on; affect
• "参数"英文翻译    parameter
• "基因作用参数" 英文翻译 :    gene-action parameters
• "弗洛里-哈金斯相互作用参数" 英文翻译 :    flory-huggins interaction parameter
• "作用参数, 运算因数,工作特性" 英文翻译 :    operational factors
• "热可用参数" 英文翻译 :    heat availability parameter
• "使用参数" 英文翻译 :    operation parameter
• "通用参数" 英文翻译 :    common parameter
• "引用参数" 英文翻译 :    referendce parameters
• "使用参数控制" 英文翻译 :    upc usage parameter control; usage parameter control
• "占用参数控制" 英文翻译 :    upc
• "保留名称使用参数" 英文翻译 :    reserved name use parameter
• "过程调用参数化" 英文翻译 :    parameterization of procedure calls
• "函数调用参数太少" 英文翻译 :    too few parameters in call
• "指针和引用参数" 英文翻译 :    pointer & reference parameters
• "反作用参照团体" 英文翻译 :    negative reference group
• "正作用参照团体" 英文翻译 :    positive reference group
• "船用参数自动记录器" 英文翻译 :    automated marine date logger
• "钣金设计通用参数预设置" 英文翻译 :    smd general preference
• "供民用参考" 英文翻译 :    civilian application
• "合用参麦组" 英文翻译 :    suk
• "善用参考书" 英文翻译 :    make good use of the reference books
• "使用参考书" 英文翻译 :    to use reference books
• "信用参考" 英文翻译 :    credit reference
• "医用参考" 英文翻译 :    medical reference source

• Experimental study on the interaction characteristics between single direction plastic geogrid and soil
  筋土界面相互作用参数和加筋垫层处理软基的性状研究
• German standard methods for examination of water , waste water and sludge ; summary action and material characteristic parameters group h ; determination of the chemical oxygen demand in the range over 15 mg l
  德国对水废水和污泥的标准检验法.总的作用参数和材
• German standard methods for the examination of water , waste water and sludge ; parameters characterizing effects and substances group h ; determination of bound nitrogen after reduction with devarda ' s alloy and catalytic digestion
  德国对水.废水和淤泥的统一检验方法.作用参数和物质
• From the concentration dependence of bsa apparent diffusion coefficients , protein interaction parameters have been regressed . it bears a net effective charge of - 9 . 0 and has a hamaker constant of 2 . 8ket
  根据扩散系数随蛋白浓度变化的斜率与离子浓度变化的相关性，回归出了蛋白相互作用参数，蛋白所带的有效电荷zp二一9 . oe 、 hamaker常量= 2
• The parameters of dispersants was optimized and the factors affecting dispersing effects are analyzed . the operation mechanisms of the dispersants are discussed . by the methods of contrastive and orthogonal experiments , the excellent dispersants were found
  分析了影响tio _ 2颗粒分散性能的各种因素，并讨论了各种分散剂的作用机理，找到了各种分散剂的最佳作用参数。
• Three characteristic features are found . first , for the same set of atom - light interaction parameters , the indices of refraction are large at three different frequencies where the absorption vanishes . these three frequencies are determined by the resonance transition frequencies between dressed states produced by the strong driving field
  我们发现了三个重要特征：首先，在相同的原子和光相互作用参数条件下，同时存在三个无吸收折射率增强点，这三个点所处的频率位置由驱动场产生的修饰态之间的共振跃迁决定。
• 6 c is contrast to the literature data . the lle data of the system measured at 40 c , which is correlated in virtue of nrtl or uniquac equation . the correlated parameters are used to the simulation of azeotropic distillation process . in addition , the vle data of the system acetic acid - water - n - butyl acetate at 1 atm from literature are correlated by virtue of nrtl - hoc and uniquac - hoc model , and the parameters are also used to azeotropic distillation simulation . by tint of a kind of computer language matlab , the binary parameters is correlated , stability of original liquid is checked , liquid - phase splitting calculation and simulation of heterogeneous azeotropic distillation are performed
  自制了液液平衡釜，实验测得24 . 6时乙酸-水-乙酸异丙酯液液相平衡数据与文献数据吻合，验证了平衡釜的可靠性，测定了40时此体系的液液相平衡数据，对40实验数据进行了uniquac方程和nrtl方程参数的拟合；利用uniquac - hoc模型和nrtl - hoc模型，对乙酸-水-乙酸丁酯体系三元相平衡体系相平衡数据的进行拟合，得到水-乙酸丁酯间uniquac方程和nrtl方程的二元交互作用参数。
• At last , we propose a method to generate two mode su ( 1 , 1 ) intelligent states for the center of mass and relative motional modes for two trapped ions . in our scheme , only three laser beams are employed , and their directions are all the same as the direction of the two trapped ions " alignment . under some initial conditions , our desired states are obtained as the steady - state solution to the master equation of the system
  最后我们在此模型之上提出了一种新的运用离子对的质心振动模和相对振动模进行双模su ( 1 , 1 )智能态的制备方案，它是系统在适当的初始条件下达到稳态时自动生成的态，它不必通过控制繁杂的相互作用参数而得到，因此该方案具有很大的实际应用价值。
• Aim : to analyze the mechanism , thermadynamic theoretical basis , dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size , distribution and form of pores , so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled . methods : considering from the structural characteristics of tissue engineered materials , the methods of preparing porous membrane using tips technique , the hermadynamic theoretical basis , dynamic mechanism and influencing factors were analyzed , the problems and investigative directions in the future were also analyzed . tips technique is a process of phase separation of polymer homogenous solution under quenching , and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant , polymer concentration and polymer molecular mass , etc . conducted , including determination of polymer - solvent system phase diagram , study of form and appearance of porous membrane of different thickness , study of form and appearance of porous membrane prepared with systems of different x , which is the parameter of polymer - solvent interaction
  目的:分析热致相分离成膜过程的机理、热力学理论基础、动力学机制以及影响因素,以便充分掌握影响孔度大小、分布、形态的因素,使孔度调控范围得以拓宽,使多孔膜的制备能重复可控.方法:从组织工程材料结构特点出发,分析热致相分离聚合物多孔膜的制备方法及该法成膜的热力学理论基础、动力学机制以及影响因素.并分析实验中存在的问题及今后的研究方向.结果:以热致相分离法可制备聚合物多孔膜.热致相分离法制备多孔膜是高聚物均相溶液在淬冷条件下发生相分离的过程,它适用于上临界共溶温度型聚合物一稀释剂二元体系.热致相分离法成膜的过程,可以认为是旋节线机理占主导地位.热致相分离法制备的微孔材料,其孔隙率、孔径大小、结构形态与聚合物稀释剂的种类、组成配比、聚合物浓度、聚合物分子量等因素密切相关.结论:可采用热致相分离技术制备多孔膜,通过改变不同的成膜条件可获得一系列不同孔径尺寸和孔径分布的多孔膜材料.对热致相分离成膜过程中聚合物-溶剂体系的相图测定,不同厚度的多孔膜形貌研究,不同x (聚合物-溶剂相互作用参数)体系所制备的多孔膜形貌等需深人研究
• Based on the pull - out tests data between geogrids and expansive soil / sands arranged by the orthogonal table l9 ( 34 ) , the following conclusions are reached : 1 ) the displacement - properties of pullout tests depend on the pullout speed . the law of factors " affecting degree , which influences the parameters between geogrids and soils in the pulling - out procedure , is obtained . with the concept of " equivalent pull - out displacement ( x ) " brought forward , the whole process of pull out tests is divided into two process - " main process ( when x 1 . 0 ) " and " residual process ( when x 1 . 0 ) " , and three stages - static friction resistance stage , slip friction resistance stage , and residual friction resistance stage
  基于正交设计表l9 ( 3 ~ 4 )分别安排了影响因素与土工格栅膨胀土或砂土界面相互作用参数的拉拔试验数据，获悉： 1 )拉拔试验位移特性主要取决于影响因素中拉拔速率；通过分析并获取影响因素对筋土界面相互作用参数的影响程度及其在拉拔试验过程中的变化规律，提出了当量拉拔位移( x )的概念，并据此将拉拔试验全过程划分成“主过程( x 1 . 0 ) ”和“残余过程( x 1 . 0 ) ” ；且将影响因素对拉拔力或摩擦阻力系数的影响程度分成三阶段(静摩擦阻力阶段、滑动摩擦阻力阶段，残余摩擦阻力阶段) ； 2 )不同(规范)定义的筋土界面摩擦阻力系数数值相差较大，但影响因素对摩擦阻力系数影响程度及其变化规律不会因不同(规范)定义而受到影响。