刮膜的英文

发音:

"刮膜"怎么读"刮膜"的汉语解释用"刮膜"造句

英文翻译手机版

knifing

"刮"英文翻译 shave
"膜"英文翻译 membrane
"刮膜式蒸发器" 英文翻译 : scraped film evaporator; wipe film evaporator
"刮模面" 英文翻译 : mcld
"刮磨" 英文翻译 : scraped finish
"刮面式套管结晶机" 英文翻译 : scraped-swrface exchanger
"刮抹" 英文翻译 : spatulation
"刮面式换热器" 英文翻译 : scraped surface heat exchanger
"刮墨刀" 英文翻译 : doctor; scraping blade; squeegee
"刮面石" 英文翻译 : shaving stones
"刮墨刀角度" 英文翻译 : doctor blade angle
"刮面热交换器" 英文翻译 : scraped-surface exchanger

例句与用法

Numerical simulation on wiped film distillation of dbp - dbs
刮膜分子蒸馏过程数值模拟
Mathematic model of mass transfer and heat transfer of wiped film molecular distillation
刮膜分子蒸馏传质和传热的数学模型
When coagulant bath temperature was at 15 c , the flat membrane was smooth , and the defects disappeared
温度为15时，所刮膜平整光滑，缺陷消失。
For flat films , the cellulose chains are almost unoriented within the plane parallel to the film surface
另外，刮膜速度、拉伸比和吹胀比对膜强度和超分子结构的影响也很大。
The strength of flat film made by casting method is only 55mpa , while that of tubular film made by blown - extrusion method is high to 250mpa and is 2 . 5 times strength of cellophane
刮膜法制备的平膜强度较低，而吹膜法制备的管膜强度达250mpa ，是玻璃纸的2 . 5倍，这与分子链的取向有关。
The optimized process parameters are : the concentration of casting solution is higher than 9wt % , casting speed is 0 73m / min , temperature of wash bath is 45 and post - treatment is used
当铸膜液浓度在9wt以上，刮膜速度为0 . 73m min ，水洗浴温度为45 ，并增加热处理和塑化处理时，膜的分离性能较好。
With an increase of nmmo concentration of coagulation bath or concentration of casting solution , the crystallinity of membrane increases . however , an increase of temperature of coagulation bath is accompanied by a decrease of crystallinity of membrane
膜的结晶度随铸膜液浓度、凝固浴浓度、刮膜速度的增加而增大，随凝固浴温度的升高而降低。