制动杆的英文

发音:

"制动杆"怎么读用"制动杆"造句

英文翻译手机版

arresting lever
brake arm
brake bar
brake lever
brake pull rod
brake rod
friction lever
friction-lever
skidding lever
stop lever

"制动"英文翻译 braking; retardation; retain ...
"杆"英文翻译 shaft; rod; bar
"横向制动杆" 英文翻译 : brake cross lever
"轮制动杆" 英文翻译 : wheel brake lever
"前制动杆" 英文翻译 : front brake lever
"手制动杆" 英文翻译 : hand lever
"跳秒轮, 制动杆" 英文翻译 : jumping second whip
"停车制动杆" 英文翻译 : brake parking lever; brake parking paddle; parking brakelever
"制动杆弹簧" 英文翻译 : brake rod spring; brake-rod spring
"制动杆销" 英文翻译 : brake rod fitting pin
"制动杆爪" 英文翻译 : brake lever latch; brake lever pawl
"双秒针制动杆" 英文翻译 : split-second collet
"双圆盘制动杆" 英文翻译 : roller whip
"制动杆调整器" 英文翻译 : brake rod adjuster; brake-rod adjuster
"制动杆配合销" 英文翻译 : brake rod pin
"制动杆扇形板" 英文翻译 : brake lever quadrant; brake lever sector; brake lever segment
"制动臂率, 制动杆倍率" 英文翻译 : brake leverage
"制动杆，制动手柄，制动踏板" 英文翻译 : brake leer; brake lever
"螺钉摆轮制动杆" 英文翻译 : screw balance whip
"双秒针制动杆盖座" 英文翻译 : split-second collets cover support
"双秒针制动杆簧" 英文翻译 : split-second collet spring
"双圆盘制动杆簧" 英文翻译 : roller whip spring
"制动杆端叉形铁" 英文翻译 : brake rod crevice
"手制动器驱动杆调整叉" 英文翻译 : hand brake drive rod adjusting fork
"双秒针制动杆偏心销" 英文翻译 : split-second collet support eccentric

例句与用法

The trucks were themselves pulled off the rails, apparently by the brake rods connecting them to the car body .
车轮也从轨道上逸脱，这显然是由于车辆与车辆之间有制动杆相连所致。
Brake lever quadrant
制动杆扇形板
Brake lever segment
制动杆扇形板
Brake parking lever
停车制动杆
Brake cross lever
横向制动杆
Stop bar over the rolls which , when activated , will instantly stop and alternatively reverse the rolls
制动杆在启动时，可立即停止辊转动或使其反向转动。
Thirdly , in term of the results of testing and calculation , the displacement and libration , the difference of altitude , the flexibility and strain of crane - beams are all generally analysed , especially the reason why the crane - beams are attaint is lucubrated , and the reasons why the trigging pole is ruptured , the upper wingspan is damaged , the orbital movement , the exceptional incline of colums are open out , which has instructional significances that improve the design of the steel frame of the coke made by dry flameout
第三，根据检测和计算结果，对钢框架的位移和振动、框架高差、吊车梁挠度和应变等进行了全面的分析，特别对吊车梁系统的损伤原因进行了深入分析，揭示了制动杆件断裂、上翼缘磨损、轨道窜动、柱异常倾斜等一系列损伤现象的原因，对于改进干熄焦钢框架的设计有着直接的指导意义。
And it investigates the appearance condition ( including joint , crack , eroding , corrosion , braking pole device rupture , crane - girder ' s gnawing railway and so on ) of the whole crane - girder system on the spot , at the same time , it also actually examines the stress of the beam , chemical ingredient , distortion and railway excursion , etc . through sampling , and based on the actually examined results , it checks and calculates the carrying capacity of crane - girder system . then , based on the investigating on the spot and the calculated result , it discusses the mechanism of fatigue failure of the upper part of welded steel crane - girder , analyses the reason of steel crane - girder in the high - frequency emerging the fatigue crack , institutes the strengthened method of damaged steel crane - girder of accurate packing up workshop of the primary mill plant . finally , it presents some advice and suggestions for the repairing and strengthening method of fatigue crack of upper part of steel crane - girder in the high - frequency
针对包钢初轧厂精整车间钢吊车梁上部区域出现裂缝这一问题，本文首先综述了国内外关于焊接钢吊车梁上部区域疲劳裂缝的研究现状；其次对整个吊车梁系统的外观情况(包括连接、裂缝、腐蚀、锈蚀、制动杆件断裂、吊车啃轨等)进行了现场调查，抽样实测了梁的应力、化学成分、变形及轨道偏移等，根据实测结果，对吊车梁系统的承载能力进行了验算；然后，根据现场调查及计算结果，探讨了焊接钢吊车梁上部区域疲劳破坏的机理，分析了重级工作制钢吊车梁出现疲劳裂缝的原因，制定了初轧厂精整车间破损钢吊车梁的加固方案；最后就重级工作制钢吊车梁上部区域出现疲劳裂缝的修复与加固方案提出了一些意见和建议。