后规格化的英文

• post normalization
• postnormalization

• "后"英文翻译    behind; back; rear
• "规格化"英文翻译    normalization; standardizati ...
• "规格化" 英文翻译 :    normalization; standardization; normalizing; standardizing◇规格化数 normalized number
• "成品规格，切边后规格" 英文翻译 :    trimmed size
• "标准化，规格化" 英文翻译 :    normalization
• "成品规格化" 英文翻译 :    typical dimension production
• "反向规格化" 英文翻译 :    denormalization
• "非规格化" 英文翻译 :    non specification; nonspecification
• "规格化变换" 英文翻译 :    normalization transformation
• "规格化变量" 英文翻译 :    normalized variable
• "规格化操作" 英文翻译 :    normalization operation
• "规格化程序" 英文翻译 :    normalization routine
• "规格化的" 英文翻译 :    normalized
• "规格化函数" 英文翻译 :    normalized function
• "规格化结果" 英文翻译 :    normalized result
• "规格化数" 英文翻译 :    normalized number; standardizing number
• "规格化尾数" 英文翻译 :    normalized mantissa
• "规格化响应" 英文翻译 :    normalized response
• "规格化形式" 英文翻译 :    normal form; normalized form
• "规格化原则" 英文翻译 :    principle of specification
• "规格化值" 英文翻译 :    normalized value
• "使规格化" 英文翻译 :    unitise; unitize
• "数值规格化" 英文翻译 :    number normalization
• "预规格化" 英文翻译 :    prenormalization; prenormalize
• "规格化程序, 规格化例程" 英文翻译 :    normalization routine

• According to the task and delay information of the floating - point unit , it was implemented with three - stage pipeline , including pre - normalization stage , calculation stage and post - normalization stage . approximately , the delay of each stage is equal with each other . also , floating - addition , floating - subtraction and floating - multiplication can been implemented by the floating - point unit
  根据浮点单元承担的任务及延迟信息，采用三级流线实现：前规格化级( pre - normalizationstage ) 、计算级( calculationstage ) 、后规格化级( post - normalizationstage ) ，每一级的工作量和延迟近似相等。
• The algorithm and its implementation of the leading zero anticipation are very vital for the performance of a high - speed floating - point adder in today s state of art microprocessor design . unfortunately , in predicting " shift amount " by a conventional lza design , the result could be off by one position . this paper presents a novel parallel error detection algorithm for a general - case lza
  目前国际上已有很多算法对前导0预测算法进行了研究，但是出于设计方法和延迟等方面的限制，大部分前导0预测算法都为非精确算法，其预测结果可能与真实加法结果中前导0的个数产生一位的误差，这个误差需要在浮点加法的后规格化过程中进行修正，因此反过来又增加了浮点加减算法的关键路径延迟。

• 后规格化的法语：post-normalisation