吸入管的英文

• draft tube
• draw lift
• induction pipe
• inhalant siphon
• inlet manifold
• intake pipe
• snore
• sucker
• suction chute
• suction line，return line
• suction pipe
• suction tube
• suctionpipe
• tail (or suction) pipe

• "吸"英文翻译    inhale; breathe in; draw
• "入"英文翻译    enter
• "管"英文翻译    pipe; tube
• "泵的吸入管" 英文翻译 :    pumsuction
• "泵吸入管" 英文翻译 :    pump suction line; pump suction pipe; tail pipe
• "泵吸入管道" 英文翻译 :    pump suction line
• "腐吸入管" 英文翻译 :    floating suction pipe
• "空气吸入管" 英文翻译 :    air suction pipe
• "冷煤吸入管" 英文翻译 :    refrigerant suction pipe
• "冷气吸入管" 英文翻译 :    cold air suction pipe
• "水吸入管" 英文翻译 :    bilge suction pipe
• "吸入管，吸水管。" 英文翻译 :    suction pipe
• "吸入管道" 英文翻译 :    a iration pipe; aspiration pipe; intake duct; upstream line
• "吸入管汇" 英文翻译 :    suction manifold
• "吸入管接头" 英文翻译 :    suction pipe joint
• "吸入管路" 英文翻译 :    inlet line; suction line; suctionline
• "吸入管帽" 英文翻译 :    suction cap
• "吸入管线" 英文翻译 :    intake line; suction line; suctionline
• "吸入管座" 英文翻译 :    suction support
• "吸水管；吸入管" 英文翻译 :    suction pipe
• "泵吸入；泵的吸入管" 英文翻译 :    pumsuction
• "控制吸入管路" 英文翻译 :    control suction line
• "汽化器吸入管" 英文翻译 :    carburetor intake adapter
• "升压, 吸入管压力" 英文翻译 :    boost pressure; boost the octane
• "升压,吸入管压力" 英文翻译 :    boosting pressure

• Stop : shut off the valve for the suction pipe
  停机： 1 、关闭吸入管阀门。
• Carburetor intake adapter
  汽化器吸入管
• Bilge suction pipe
  水吸入管
• Petroleum and natural gas industries - induction bends , fittings and flanges for pipeline transportation systems - fittings
  石油和天然气工业.管道运输系统的吸入管弯头配件和法兰.配件
• Petroleum and natural gas industries - induction bends , fittings and flanges for pipeline transportation systems - part 2 : fittings
  石油和天然气工业.管道运输系统的吸入管弯头配件和法兰.第2部分:配件
• The flow conditions in the pump sump are very complex . kinds of vortices occur especially in and around the pump bell . these are common problems , which lead to poor pump performance
  但其内部流场非常复杂，特别是在吸入管的周围，分布着十分复杂的涡，这些涡的存在使泵站的性能恶化。
• These results showed that the vortices always appeared near the center of the inlet and the vertical velocity was much bigger than the horizontal ones . by measuring the size of air core and the probability of its appearance , we found that the probability of middle - size air core is the biggest while the ratio of runoff is big
  从中发现漩涡总是出现在吸入管中心附近，并且在吸入管入口范围内，总是竖直方向的速度占主导地位； ( 4 )通过测量流场中出现的气核数量，研究了气核的尺寸以及出现概率。

• 吸入管的日语：きゅうにゅうかん 吸入管。
• 吸入管とは意味吸入管 suction pipe[機械]〈97F0026:造船用語―機関ぎ装〉