工作压差的英文

• operating pressure differential
• operting differential pressure

• "工作"英文翻译    work; operation; working; op ...
• "压"英文翻译    press; push down; hold down; ...
• "差"英文翻译    send on an errand; dispatch
• "最大工作压差" 英文翻译 :    maximum operating pressure differential; maximum operationg water depth
• "最小工作压差" 英文翻译 :    minimum operationg pressure differential
• "工作压板" 英文翻译 :    action switch
• "工作压力" 英文翻译 :    actuating pressure; job stress; operating pre ure; operating pressure; operation pressure; service pressure; service-pressure; serviceebility pressure; w.p. working pressure; working pre ure; wwork pressure; wworking pressure
• "工作压力比" 英文翻译 :    operating pressure ratio
• "工作压力角" 英文翻译 :    operating pressure angle
• "工作压力为" 英文翻译 :    o065mpao098mpampa
• "工作压强" 英文翻译 :    working pressure
• "工作压头" 英文翻译 :    operating head; working head; working pressure head
• "安全工作压力" 英文翻译 :    safe working pressure; safe working stress; swsafety working pressure
• "地面工作压力" 英文翻译 :    stp
• "额定工作压力" 英文翻译 :    nominal working pressure; rated operating pressure; rated working pressure; service pre ure; service pressure
• "工作压力大于" 英文翻译 :    o098mpaa
• "工作压力范围" 英文翻译 :    range of working pressure
• "工作压力空气" 英文翻译 :    working pressure air
• "工作压力上限" 英文翻译 :    maximum working pressure
• "工作压力水头" 英文翻译 :    working-pressure head
• "工作压力下限" 英文翻译 :    minimum working pressure
• "公称工作压力" 英文翻译 :    nominal operating pressure; nominal working pressure
• "锅炉工作压力" 英文翻译 :    boiler working pressure
• "缓解工作压力" 英文翻译 :    reviving working stress
• "井底工作压力" 英文翻译 :    operating bottom hole pressure

• Minimum operationg pressure differential
  最小工作压差
• Maximum operating pressure differential
  最大工作压差
• Operating pressure differential
  工作压差
• Operting differential pressure
  工作压差
• Service conditions - line media , temperature , and maximum operating differential pressure
  应用环境-管路流体介质，温度和最大工作压差。
• Choose models according to max oprating temperature , max oprating pressure , max operating differential pressure that listed the parameter table
  用户根据用汽设备的最大用汽量（乘以选用倍率系数2 - 3倍） ，最高工作压力、最高工作温度、最高工作压差对照表中参数选型。