无定型结构的英文

• undefined structure

• "型"英文翻译    mould; model
• "结构"英文翻译    structure; composition; cons ...
• "无定型结晶" 英文翻译 :    imperfect crystal formation
• "不定型结构" 英文翻译 :    undefined structure
• "定型结构" 英文翻译 :    stereotyped structure
• "无定型" 英文翻译 :    amorphous forms
• "无定型的" 英文翻译 :    unformed
• "无定型基质" 英文翻译 :    amorphous ground substance
• "无定型人格" 英文翻译 :    amorphic personality; amorphous personality
• "无定型石墨" 英文翻译 :    amorphous graphite
• "无定型物" 英文翻译 :    amorpphis
• "型结构" 英文翻译 :    caesium chloride structure; h-form/holding company h; mercury i chloride structure; multidivisional structure m; nacl－type structure; unitary structure
• "无定型相；非品相" 英文翻译 :    amorphous phase
• "y型结构" 英文翻译 :    y-shaped structure
• "苯型结构" 英文翻译 :    benzenoid structrue; benzenoid structure
• "扁平型结构" 英文翻译 :    flat hierarchies
• "并列型结构" 英文翻译 :    bilateral structure
• "层型结构" 英文翻译 :    layer structure
• "叉指型结构" 英文翻译 :    interdigital structure
• "纯键型结构" 英文翻译 :    homodesmic structure
• "典型结构" 英文翻译 :    canonical structure; typical structure
• "泛型结构" 英文翻译 :    generic structure
• "方型结构" 英文翻译 :    square formats
• "非线型结构" 英文翻译 :    non-linear structure
• "蜂巢型结构" 英文翻译 :    honey comb structure; honeycombstructure

• The molecular structure of the sputtered titanium oxide films were investigated by xps and x - ray diffraction . it was found that the ratio of ti / o increases when pressure increases , and there is a optimum ratio of ar / o2 for the sake of obtaining more tio2 on pet surface
  利用x射线衍射法( x - ray )对溅射沉积膜的表面物相结构进行了研究，发现在本实验室条件下溅射生成的膜均是无定型结构。
• The xrd showed that the crystalline of samples prepared in various o _ ( 2 ) partial pressure and various sputtering power was amorphous , the anatase crystalline formed when heat treatment temperature was above 450 , and heat treatment temperature was higher , the crystalline was better . sem showed that the crystal grams formed on the surface of films when the o _ ( 2 ) partial pressure was high ; the obvious and big grains appeared hi the surface with improvement of heat treatment temperature
  Xrd分析表明，不同氧气分压下制备的样品基本是无定型结构，不同溅射功率下制备的样品基本也是无定型结构，当热处理温度高于450时，试样出现了晶面趋向为( 101 )的锐钛矿相，随着热处理温度的升高，结晶程度增大； sem分析表明：随着氧气分压的升高，试样表面出现微小结晶颗粒；随着热处理温度的升高，试样表面出现了相当明显的结晶颗粒，试样的比表面积增大。
• The difference of reactive mechanisminduced the difference of their structure . v _ 2o _ 5 product prepared by melting - cooling showed more notable undefined structure . after heat - treating under300 , particle size becomes smaller , and aggregate to globate grain , showesbetter electrochemical performance at low charge - discharge rate
  熔融淬冷法合成的样品其无定型结构更明显，前驱体经过300热处理后，材料的粒径变细，团聚成球状的颗粒，球状特征更显著，在低倍率下具有较好的电化学性能。
• The structural characterization of v _ 2o _ 5 compounds were measured bymeans of differential thermoanalysis ( dta ) and thermogravimetry ( tg ) , scanning electron microscopy ( sem ) , and x - ray diffraction ( xrd ) . the testsreveale that materials which were prepared by sol - gel ( inorganic sol gel andmelting - coling ) showed that the amorphous structure , and the interlayer spacingenlarge a lot than that of crystalline v _ 2o _ 5
  采用热重与差热( tg - dta ) ，扫描电子显微镜( sem ) ， x射线衍射( xrd )等测试手段对材料的结构性能进行表征，结果显示两种溶胶-凝胶法(无机溶胶凝胶法和熔融淬冷法)制备的v _ 2o _ 5材料均为无定型结构，其层面间距均比晶体v _ 2o _ 5成倍增大。