残余压应力的英文

• rasidual compressive stress
• residual compressive stress

• "残余"英文翻译    remnants; remains; residue; ...
• "压"英文翻译    press; push down; hold down; ...
• "应力"英文翻译    stress; strain; tension; cha ...
• "压应力" 英文翻译 :    compre ive stre; compre ivestre; compressing stress; compression stress; compressional stress; compressive resistance; compressive stress; crushing stress; pressure stress; stress
• "比压应力" 英文翻译 :    specific compressive stress
• "表面压应力" 英文翻译 :    compressive stress at surface
• "承压应力" 英文翻译 :    bearing pressure; bearing stress
• "垂向压应力" 英文翻译 :    vertical compressive stress
• "垂直压应力" 英文翻译 :    vertical compressive stress
• "单轴压应力" 英文翻译 :    einachsige druckbeanspruchung uniaxial compression load
• "当量压应力" 英文翻译 :    equivalent compressive stress
• "地压应力" 英文翻译 :    lithostatic stress
• "电压应力" 英文翻译 :    voltage stress
• "电压应力坡" 英文翻译 :    voltage-stress gradient
• "法向压应力" 英文翻译 :    direct compressive stress
• "风压应力" 英文翻译 :    wind stress
• "合成压应力" 英文翻译 :    resultant compressive stress
• "恒压应力" 英文翻译 :    constant voltage stress
• "挤压应力" 英文翻译 :    extrusion stress; racking stress
• "静液压应力" 英文翻译 :    hydrostatic stress; hydrostatic tension
• "径向压应力" 英文翻译 :    radial compression stress; radial compressive stress
• "局部压应力" 英文翻译 :    partial pressure
• "抗压应力" 英文翻译 :    compression stress; compressive stress; crushing stress; pressure load
• "临界压应力" 英文翻译 :    critical compressive stress; criticalcompressivestress
• "内压应力" 英文翻译 :    internal pressure stress

• There are three types of wrinkle which frequently occur in the sheet metal forming process : flange wrinkling , wall wrinkling , and elastic buckling of the undeformed area owing to residual elastic compressive stresses
  在金属板料成型加工中通常存在三种类型的起皱现象：法兰起皱，侧壁起皱，和由于残余压应力在未变形区产生的弹性变形。
• On basis of numerical simulation , the optimized weling technological has been vadidated and adjusted by plane test , results show that residual stress of both ends welded in advance can be decreased by the interspace welded later , and decreasing effect is the most obvious in the 50mm range of the interspace ; for local heating , it is 60mm from the edge of heated area to decrease residual stress
  通过平板试验得到了分段焊与局部加热合理工艺参数,并在此基础上,对转轮的焊接残余应力场进行了调整与控制,使叶片出水边危险区域附近产生了较大的残余压应力,且转轮整体的残余应力水平低于转轮材料屈服极限的三分之一。