湿膜的英文

• film, wet
• moisture film
• w/f(wet film)
• wet film

• "湿"英文翻译    wet; damp; humid
• "膜"英文翻译    membrane
• "润湿膜" 英文翻译 :    wetting film
• "恒温恒湿膜" 英文翻译 :    climatic membrane
• "湿胶片,湿膜" 英文翻译 :    wet films
• "湿膜测厚仪" 英文翻译 :    wet film thickness gauge
• "湿膜厚度" 英文翻译 :    wet-film thickness
• "湿膜厚计计" 英文翻译 :    wet film thickness gauge
• "湿膜压膜法" 英文翻译 :    wet lamination
• "湿膜养护剂" 英文翻译 :    wet membrane curing agent
• "湿膜粘聚力" 英文翻译 :    moisture film cohesion
• "水润湿膜" 英文翻译 :    aqueous wetting film
• "湿膜厚计计；湿膜测厚仪" 英文翻译 :    wet film thickness gauge
• "湿模铸件" 英文翻译 :    green castings
• "湿模数" 英文翻译 :    wet modulus
• "湿模式" 英文翻译 :    wet model
• "湿模砂" 英文翻译 :    green sand
• "湿模量" 英文翻译 :    wet modulus; wetmodulus

• Apply less wet film thickness . increase pressure
  减少湿膜厚度，加大压力。
• Test methods for measurement of wet film thickness of organic coatings
  有机涂层湿膜厚度的测试方法
• Standard practice for measurement of wet film thickness by notch gages
  刻痕量规测定湿膜厚度的标准实施规程
• Influence of technological parameters on the humidity controlling properties of pan bentonite intercalation composites
  插层复合调湿膜的性能
• The wet layer of film shall be immediately measured with a wet film thickness gauge after the paint is applied
  在涂装结束后，应立即用湿膜计对湿膜进行厚度测量。
• If the required paint film thickness has not been achieved , the additional coats should be applied till the specified thickness is attained
  如果未达到要求的湿膜厚度，应覆涂直到满足指定的湿膜厚。
• The system can carry out such works as follows : acquisition of humidity states in the air should be carried out and the humidity should be sent to main control module
  本文以湿膜式工业加湿器为控制对象，完成了湿膜式工业加湿器电控系统的设计。
• The humidification mechanism and humidification capability have been analyzed in theory . this is the foundation of design of electronic control system
  对湿膜式工业加湿器的加湿机理和加湿性能进行了理论上的分析，为电控系统的设计奠定了基础。
• Firstly , choose an appropriate solution system to make a steady solution , and then limn2o4 film precursor was prepared on stainless steel by spin coating method with the solution
  在前驱体溶液体系选择过程中,确定了最佳前驱体溶液体系组成;在最佳的前驱体溶液组成体系下,采用旋转涂覆法在不锈钢基体上制备前驱体湿膜。
• Under research in theory , this paper suggests that we should use such humidification method as follows : the vapor in humidifier should get across a roundabout room before it is sent to air . so the big beads in the vapor are deposited , and then the humidification will be even . 3
  通过理论上的研究本文建议使用如下加湿方法：湿膜式加湿器中风机吹出的水蒸气不直接进入空气中，而是经过一个迂回的空间再送到空气侧，使水蒸气经过此空间后，其中较大的水珠沉积下来，从而较好的实现均匀加湿。

• 湿膜的日语：ぬれ面 ぬれめん みかんそうとまく