烧结时间的英文

• sintering time

• "烧结"英文翻译    firing; fritting; cementatio ...
• "时间"英文翻译    time; hour
• "烧结时的生长" 英文翻译 :    growth during the sintering
• "冻结时间" 英文翻译 :    congeal time; freezing time
• "固结时间" 英文翻译 :    consolidation time
• "集结时间" 英文翻译 :    car detention time under accumulation
• "胶结时间" 英文翻译 :    geltime
• "聚结时间" 英文翻译 :    coalescence time
• "凝结时间" 英文翻译 :    coagulation time; jelling time; setting time; setting-up time; settingtime; time of coagulation; time of setting
• "审结时间" 英文翻译 :    date of conclusion of hearing
• "粘结时间" 英文翻译 :    tack time
• "烧结时辐射状收缩" 英文翻译 :    radial shrinkage on sintering
• "固结时间因子" 英文翻译 :    time factor
• "货车集结时间" 英文翻译 :    accumulation time
• "凝结时间,凝固时间" 英文翻译 :    setting-up time
• "凝结时间测定仪器" 英文翻译 :    setting a aratus; setting apparatus; settinga aratus
• "凝结时间试验器" 英文翻译 :    setting-time apparatus
• "外推最大凝结时间" 英文翻译 :    maximum extrapolated cloting time
• "固结时间对数拟合法" 英文翻译 :    logrithm of time fitting method
• "水泥凝结时间测定针" 英文翻译 :    cement needle
• "种族主义冻结时间像迪士尼" 英文翻译 :    racism frozen in time like walt disney
• "烧结" 英文翻译 :    firing; fritting; cementation; clotting; agglomeration; agglutination; [冶金学] sintering; nodulize; sinter-roasting◇烧结厂 ore-sintering plant; 烧结成型 sinter molding; 烧结锻造 sintering forging; 烧结法 sintering process; 烧结工序 sintering circuit; 烧结机 sintering machine; 烧结剂 agglutinant; 烧结料 sintering feed; 烧结裂纹 sintering crack; 烧结炉 fritting furnace; welding furnace; 烧结设备 agglomerating plant; 烧结铸石 sintering glass-ceramics; 烧结砖 baked brick
• "当完结时" 英文翻译 :    the conclusion of
• "爱在此生终结时" 英文翻译 :    our lady of the assassins; virgen de los sicarios, la
• "联结时序频率分析" 英文翻译 :    analysis joint time-frequency; analysis, joint time-frequency (jtfa)

• A defect model is suggested to account for the pl of sintered psc
  发光峰的强度随着烧结时间的增加略有下降，多孔碳化硅的发光来自于缺陷态。
• Accordingly , the degree of degradation is observed to enhance if the period of the sintering process is too long
  由此发现过度加长烧结时间有加速劣化的趋势。
• The results show that the grain size of cosb3 grows with increasing sintering temperature or sintering time
  结果表明：随着烧结温度的增加和烧结时间的延长，烧结体的晶粒有明显长大。
• Sintering time ranges from 3 to 10 hours , and sintering temperature ranges from 160ctc to 1900 ? , under an ar . protection of 1 . 0 atm
  在1 . 0atm的ar气保护下进行烧结，选用的烧结时间从3小时到10小时，烧结温度由1600到1900 。
• The highest sintering temperature was 900 c , and the sintering lasted 70 seconds . the conventional sintered magnets were sintered at 1000 c for 1h
  常规烧结的温度为1000 ，烧结时间为1h ，并分别在800和600各进行1h的回火。
• When sintering temperature and sintering time are 625 c and 7min respectively , the densenfied bulk thermoelectric materials with mean grains size of 100nm were prepared
  当烧结温度为625 ，烧结时间7min时，得到了最小平均晶粒尺寸为100nm的cosb _ 3密实块体材料。
• Any products were prepared without impurities . the sps method was used to sintering the zrnisn - based compounds . the influence of different reaction temperature and holding time to density was discussed in detail
  采用放电等离子法( sps )烧结制备zrnisn基化合物，并探讨了不同的烧结温度和烧结时间对材料致密度的影响。
• The mechanical and physical properties of the obtained w - cu composites were also tested . it was found that the property of the starting w - cu powder has a great influence on the sintering densification of the powder compacts
  对上述粉体的性能进行了表征，并研究了烧结温度和烧结时间对烧结体的物理、力学性能及组织结构的影响。
• It showed that better crystal films could formed when sintered between 350 ~ 550 for 3 hours . with the increasing of temperature and the extending of time , the diffraction apices became stronger and the crystal became bigger
  薄膜电极的烧结工艺研究结果表明,当烧结温度在350 ~ 550烧结时间为3h时得到结晶良好的limn2o4薄膜,随着温度的升高,衍射峰越来越明显,晶粒越来越大。
• As shown by the measurements , the electrical resistivity of sintered psc has a tendency of first decreasing and then increasing as the sintering temperature and / or sintering time increase . also it decreases with the increased pressure on the pressed powder compact
  对样品的电阻率进行了测量，总体呈现出随烧结时间和烧结温度的增加而先降低后增加的趋势，并随压坯的成型压力的增加而降低。