类功率放大器的英文

• amplifier class a power
• amplifier, class b power b

• "功率放大器"英文翻译    power amplifier; station amp ...
• "丙类功率放大器" 英文翻译 :    class c power amplifier
• "丁类功率放大器" 英文翻译 :    class d power amplifier
• "甲类功率放大器" 英文翻译 :    class a power amplifier
• "滑动甲类功率放大器" 英文翻译 :    sliding class a power amplifier
• "功率放大器" 英文翻译 :    power amplifier; station amplifier
• "uhf功率放大器" 英文翻译 :    uhf power amplifier
• "大功率放大器" 英文翻译 :    high-power amplifier (hpr); hpa high power amplifier
• "低功率放大器" 英文翻译 :    low power amplifier
• "高功率放大器" 英文翻译 :    high power amplifier (hpa); high power silicon rectifiers
• "功率放大器级" 英文翻译 :    power-amplifier stage
• "功率放大器件" 英文翻译 :    power amplifying device
• "光功率放大器" 英文翻译 :    ba booster amplifier
• "静功率放大器" 英文翻译 :    static power amplifier
• "图功率放大器" 英文翻译 :    image power amplifier
• "小功率放大器" 英文翻译 :    gain amplifier; low power amplifier; miniwatt amplifier
• "单声道功率放大器" 英文翻译 :    monaural power amplifier
• "低频功率放大器" 英文翻译 :    low-frequency power amplifier
• "电视功率放大器" 英文翻译 :    television power amplifier
• "电子管功率放大器" 英文翻译 :    electron tube power amplifier; electronic tube power amplifierr; electronic tube voltmeter; electronic tube voltmetre
• "电子束功率放大器" 英文翻译 :    beam power amplifier
• "电子注功率放大器" 英文翻译 :    beam power amplifier
• "多通道功率放大器" 英文翻译 :    multichannel power amplifier
• "多载波功率放大器" 英文翻译 :    mcpa multicarrier power amplifier
• "非线性功率放大器" 英文翻译 :    nonlinear power amplifier

• In the end of the thesis , we came up with a measure of the ideal inverse class - f pa design which shows a way to design rfic pa in the future
  文末提出了一种理想逆f类功率放大器的具体设计方法,为后续的rficpa设计提供了思路。
• The drive stage is made up of cascode class - f topology . a “ big ” mosfet is used in the class - e output stage . the thesis did the simulation of the pa by ads with the tsmc 0 . 18 m rf cmos model , and completed the layout of the pa
  本文设计了一种新颖的射频cmos功率放大器,采用两级差分结构,用f类共源共栅结构作为驱动级,输出级采用大尺寸mos管的e类功率放大器。
• The bluetooth chip nrf2401 uses the gfsk modulation . after analyzing and comparing the characteristic of every class power amplifiers , the thesis bring up with the idea of using a switched mode power amplifier to achieve the demanding output power and the higher efficiency
  结合“微型核”信息电子系统实现方案中nrf2401蓝牙芯片的特点,本文通过对各类功率放大器的结构和特点的分析比较,提出了采用了开关类功率放大器来实现系统输出功率要求和尽可能高的效率的设计思想。
• Next , we optimize the structure of the traditional class e power amplifier , including differential and cross - coupled feedback structure . the results by simulating the power amplifier using tsmc technology at 1 . 8ghz proves changes improved the performance efficiently , at last we finished the layout of this class e power amplifier
  紧接着对传统e类功率放大器进行了优化,提出了全差分和交叉耦合结构的e类功率放大器,采用tsmc0 . 35 msigebicmos工艺对电路进行仿真,在1 . 8ghz的中心频率下,仿真结果表明优化后的结构能够较大程度的提高e类功率放大器的性能。
• Thirdly , a state - space method to model and analyze the class e power amplifier ’ s operation has been present . after the explanation on the state - space model and the design method of class e power amplifier , we implemented class e power amplifier in tsmc 0 . 35 m sige bicmos technology , the simulating results finally proves that the accuracy and feasibility of this method
  在此基础上,提出了用状态空间模型来分析e类功率放大器,在阐述了e类功率放大器的状态空间模型和具体的设计方法后,用tsmc0 . 35 msigebicmos工艺验证了设计方法的可行性和准确性。
• As the key block of the wireless communication transmitter in rf , it is very useful in improving the output power and efficiency , lowering the loss of the supply , lowering the size and the weight , lengthening the time of communication . class e power amplifier which is suitable to amplify envelop signal is very important in modern communication system
  功率放大器( pa )作为无线通信射频发射机中不可缺少的关键电路,对于提高手机的功率效率、降低电源损耗、减小体积重量、延长通话时间有着举足轻重的作用,而适用于恒包络信号放大的e类功率放大器,更是在现代通信系统中占有十分重要的地位。