胶含量的英文

• resin content

• "胶"英文翻译    glue; gum
• "含量"英文翻译    content
• "标示胶含量" 英文翻译 :    nominal resin content
• "干胶含量" 英文翻译 :    dry rubber content
• "干橡胶含量" 英文翻译 :    dry rubber content
• "果胶含量" 英文翻译 :    pectin content
• "气溶胶含量" 英文翻译 :    aerosol load
• "树脂含量(胶含量)" 英文翻译 :    resin content
• "干胶含量的测定" 英文翻译 :    natural rubber latex concentrate-determination of dry rubber content
• "气溶胶浓度；气溶胶含量" 英文翻译 :    aerosol load
• "造纸原料果胶含量的测定" 英文翻译 :    raw fiber material determination of pectin contentt
• "含量" 英文翻译 :    content 净含量 net contents; 牛奶的乳糖含量 the lactose content of the milk; 油的脂含量 the ester content of oil
• "gc含量" 英文翻译 :    gc content; gc-content
• "氨含量" 英文翻译 :    ammonia content
• "尘含量" 英文翻译 :    dust content
• "氮含量" 英文翻译 :    nitrogen content
• "等含量" 英文翻译 :    equal size; equalsize
• "酚含量" 英文翻译 :    phenol content
• "高含量" 英文翻译 :    high assay
• "硅含量" 英文翻译 :    silica content
• "含量；容量" 英文翻译 :    content
• "含量低" 英文翻译 :    ozl
• "环含量" 英文翻译 :    ring content
• "灰含量" 英文翻译 :    ash content
• "碱含量" 英文翻译 :    alkali content

• Natural rubber latex concentrate - determination of dry rubber content
  干胶含量的测定
• Natural rubber latex concentrate - determination of dry rubber content
  浓缩天然橡胶胶乳.干胶含量的测定
• Test methods for determination of gel content and swell ratio of crosslinked ethylene plastics
  交叉链接的聚乙烯塑料膨胀率和胶含量测定方法
• Comparison between the test methods for the measurement of the gel content in xlpe insulation compounds
  交联聚乙烯绝缘料凝胶含量试验方法比较
• Standard test methods for determination of gel content and swell ratio of crosslinked ethylene plastics
  交联乙烯塑料的凝胶含量和膨胀系数的标准试验方法
• D - glucosamine hydrochloride is also blended with chitosan to prepare anti - operational adhesion membrane by solution casting
  明胶含量为9的膜显示出最佳的防粘连作用，组织相容性良好。
• It was found that the mmt was exfoliated and intercalated in san resin . the mechanical properties of the san / mmt composite were improved
  把san mmt作为母料与高胶含量的abs接枝粉料混合，发现复合材料abs mmt的抗冲，拉伸强度均有所提高。
• With the increase of silane content , the content of gelatin increased continuously and ntc phenomenon disappeared gradually . when the silane content reach a certain volume , the ntc phenomenon was eliminated completely , at one time , the content of gelatin keep stable . 4 、 heating treatment can improve ptc characteristic of composite and increase ptc intensity . when the temperature and time of
  随着硅烷含量的增加凝胶含量不断的增加， ntc现象逐渐消失，达到一定值时ntc现象消失，凝胶含量不再提高； 4 、热处理可以改善导电复合材料的ptc特性，提高它的ptc强度，热处理温度为120 ，热处理时间为30h时效果最为明显。
• The studies expressed that the tensile - strength declined with the growth of dose rate after the radiation treatment , and at the same time , the gel content had extreme value with the change of the dose rate . the surface of uhmwpe fibers showed some irregular micro - pits and dents after radiation treatment , narnely rough degree increasing . their number and deepness increased with increase of dose . and this phenomenon is the most obvious when the dose rate was 8 . 5kgy / s and the dose was 400kgy . at the same time some containing oxygen groups , including hydroxyl group , carbonyl group and carboxyl group , were introduced into the fiber surface which was exposed to the air
  研究表明， uhmwpe纤维经电子束辐照处理后，纤维的拉伸断裂强度随剂量率的增加呈下降趋势，凝胶含量随着剂量率的变化存在极值。纤维表面出现了不规则的微裂纹和凹痕，随着剂量的增大，电子束对纤维表面的刻蚀程度增加，在本研究中以剂量为400kgy剂量率为8 . 5kgy s时刻蚀效应最为明显。同时，在空气中进行辐照时，纤维表面被引入了一些含氧基团，包括羟基、羰基和羧基。