表面温度分布的英文

• surface temperature distribution

• "表面"英文翻译    surface; superficies; bounda ...
• "温度"英文翻译    temperature
• "分布"英文翻译    distribute; spread; scatter; ...
• "红外辐射加热器表面温度分布测量方法" 英文翻译 :    measuring method for the surface temperature distribution of infrared heater
• "表面温度" 英文翻译 :    face semperature; skin temperature; surface temperature
• "表面温度计" 英文翻译 :    ardometre; skin temperature meter; surface thermometer; surfacethermometer
• "外表面温度" 英文翻译 :    outside surface temperature
• "表面温度变化" 英文翻译 :    superficial alteration
• "表面温度探头" 英文翻译 :    probe for measuring surface temperature
• "炉管表面温度" 英文翻译 :    tube skin temperature
• "模腔表面温度" 英文翻译 :    cavity surface temperature
• "模芯表面温度" 英文翻译 :    core surface temperature
• "身体表面温度" 英文翻译 :    shell temperature
• "油的表面温度" 英文翻译 :    oil surface temperature
• "驻点表面温度" 英文翻译 :    stagnation point surface temperature
• "负温度分布" 英文翻译 :    negative temperature distribution
• "温度分布" 英文翻译 :    distribution of temperature; temperature distribution; temperature traverse
• "温度分布图" 英文翻译 :    temperature chart; temperature pattern; temperature picture; temperature probe; temperature profile
• "温度分布线" 英文翻译 :    temperature profile
• "表面温度传感器" 英文翻译 :    surface temperature se or; surface temperature sensor
• "表面温度电阻器" 英文翻译 :    surface-temperature resistor
• "表面温度记录仪" 英文翻译 :    skin temperature recorder
• "接触式表面温度计" 英文翻译 :    contacting surface thermometer; contacting surface thermometre
• "溶上表面温度电阻" 英文翻译 :    weld-on surface-temperature resi-stor
• "水暖毯表面温度" 英文翻译 :    wb surface temperature

• Measuring method for the surface temperature distribution of infrared heater
  红外辐射加热器表面温度分布测量方法
• In the simplified mathematical modeling , fins are taken as equivalent solid layer with nonisotropic thermal conductivity , and heat convection between fins and cooling air is considered as internal source
  对2种飞机环控系统电子设备冷却用冷板进行了实验研究，测量了不同雷诺数、不同热源分布情况下冷板的表面温度分布。
• Micro - jets impingement cooling heat sink is used to cool the high power lda owing to the very thin hydrodynamic and thermal boundary layers in the impingement region when a jet impinges on a surface . reasonable array of jets can develop the uniform of temperature distribution on target very much
  微射流阵列冷却热沉,是利用射流冲击在驻点区能产生很薄的边界层来提高换热效率的,合理的布置射流孔,可以极大的提高被冷却表面温度分布的均匀性。
• The main work lists as following : 1 on the condition that cfrc is an macroscopically isotropic material , the governing equations of electric and thermal conduction for the inspection were established ; the current density and joule heat distribution around several kinds of flaws were investigated 2 by fem , the process of inspection was simulated ; the current density , joule heat and temperature distribution were also investigated , and the simulation results were contrasted with experimental data
  主要工作为： 1 、将机敏混凝土合理假定为宏观各向同性材料的基础上，建立了检测过程中的热、电传导相关的控制方程；并研究了几种不同缺陷周围检测过程中的电流密度、焦耳热分布规律。 2 、通过有限元方法对机敏混凝土的电热场进行了模拟分析，研究电流密度、焦耳热分布及试件表面温度分布变化规律并与实验所得试件表面温度场进行了对比分析研究。
• According to heat load source of die cavity , temperature distribution gradient equations and heat flux equations and the peak value equations of temperature load at die cavity surface have been obtained with research of temperature distribution and transfer laws of die surface by unsteady heat transfer theory
  摘要根据锻模型腔热负荷来源，通过非稳态传热理论，分析研究了模具工作表面层的温度分布与传递规律，给出了型腔表面温度分布梯度和热流密度公式，并给出了锻模型腔表面的温度负荷峰值的计算公式。
• To make the thermal efficiency best , y , a , av / as should be : r : [ 60 - 75 ] a : [ 1 - 1 . 5 ] av / as : [ 0 . 8 - 1 ] in this paper , numerical model of solar radiant floor heating system is also built . the model of numerical model is solved by finite differance method . the smaller the distance to the tube is , the higher the temperature on the surface of the floor is
  地板表面相邻两管间水平方向的温度分布：距离加热管越近，温度越高；两管中间处温度最低；供回水温差越小，地板表面温度分布越平缓；在供回水温度和排管间距均一定的情况下，地板覆盖层厚度越大，其温度分布越为平缓，对应的地板表面温度分布越均匀。