轴毂的英文

• hub
• shaft bossing

• "轴"英文翻译    axle; shaft
• "毂"英文翻译    hub; nave
• "曲轴毂" 英文翻译 :    crank boss
• "尾轴毂" 英文翻译 :    shell bossing; stern bossing
• "后轴毂键" 英文翻译 :    rear axle hub key
• "桨毂，轴毂，套筒" 英文翻译 :    hub
• "球形轴毂" 英文翻译 :    bulbobs bossing; bulbous bossing
• "托架轴毂" 英文翻译 :    bracket boss
• "尾架轴毂" 英文翻译 :    strut hub
• "尾柱轴毂" 英文翻译 :    boss of the propeller post; propeller post bossing; stern boss
• "轴毂端支架" 英文翻译 :    boss end bracket
• "轴毂倾角" 英文翻译 :    bossing slope
• "轴毂涡流" 英文翻译 :    boss eddy
• "轴毂铸件" 英文翻译 :    boss casting
• "车轮轴毂间隙" 英文翻译 :    wheel play
• "双推进器轴毂" 英文翻译 :    spectacle bossing
• "轴毂艉端理论线与中剖面间夹角" 英文翻译 :    bossing termination angle
• "轴胴材(木船)" 英文翻译 :    shaft box (or log)
• "轴胴材" 英文翻译 :    shaft box
• "轴轭" 英文翻译 :    axial yoke; axle yoke
• "轴榈" 英文翻译 :    licuala fordiana
• "轴纣蒸汽磁汽器" 英文翻译 :    gland condenser

• Small craft with inboard engine - propeller shaft ends and bosses with 1 : 10 taper
  舱内机小艇.锥度为1 : 10螺旋浆轴端和轴毂
• Owing to considering the existence of stress concentration , to carry out de - sign and check on interference fit joint of hub by the use of finite element method are more tally with the actual situation , thus more reasonable
  由于考虑了应力集中的存在，用有限元分析方法对轴毂过盈联接进行设计和校核，更符合实际情况，从而更全理。
• A detailed analysis on interference fit of hub was carried out by means of elastic mechanics and finite element method , in view of the above , the shortcomings of elastic mechanics method and the advantages of finite element method have been pointed out
  摘要用弹性力学和有限元法对轴毂过盈联接进行了详细的分析，据此指出了弹性力学方法的弊端和有限元方法的优势。