部分工况的英文

• partial load condition

• "部分"英文翻译    part; section; portion
• "工况"英文翻译    operating mode; working cond ...
• "部分工时" 英文翻译 :    parttimee
• "部分工程标准" 英文翻译 :    division engineering standards
• "部分工作负荷" 英文翻译 :    partial service load
• "完成部分工程" 英文翻译 :    partial performance of works
• "部分负荷工况" 英文翻译 :    partial load condition; partial load mode
• "各部门内部分工" 英文翻译 :    intrabranch division of labour
• "分工" 英文翻译 :    divide the work; division of labour 社会分工 social division of labour; 专业分工 division of labour based on specialization
• "工况" 英文翻译 :    (动力设备的工作情况) operating mode; working condition◇工况分析 [计算机] performance analysis
• "永久丧失部分工作能力" 英文翻译 :    permanent partial incapacity
• "所以你的部分工作是研究性的" 英文翻译 :    so some of your work is research
• "他完成了自己的那部分工作以后又去帮助别人" 英文翻译 :    after finishing his share of the work he went to help the others
• "分工、部门" 英文翻译 :    div division
• "分工器" 英文翻译 :    demultiplexer
• "分工序" 英文翻译 :    operation break down; operation break-down; operationbreakdown
• "分工制" 英文翻译 :    division of labour
• "筛分工" 英文翻译 :    screener
• "泵工况" 英文翻译 :    pumoperating condition; pumoperating duty
• "变工况" 英文翻译 :    manoeuvring condition; variable working condition; varying duty
• "干工况" 英文翻译 :    dry cooling condition
• "工况图" 英文翻译 :    working conditions chart
• "全工况" 英文翻译 :    all regime
• "湿工况" 英文翻译 :    wet cooling condition
• "机能分工机能分工" 英文翻译 :    division of function

• This paper discusses the influence of several parameters in heat release rate formula on the working process and proceeds with numerical simulation to the working process in part load condition according to the locomotive character
  本文讨论了放热率中几个参数对工作过程的影响，并且按牵引特性对部分工况进行了计算。
• 3 . the results of model test were analyzed . it is concluded that the performance of the model turbine is satisfying , with press pulsation on some operation point exception
  西安理工大学工程硕士学位论文3 、通过对模型验收试验的结果进行详细的分析，结果显示除部分工况点的压力脉动值外，模型转轮的各项性能满足合同要求。
• This dissertation delivers ecu hardware design scheme and discusses its feasibility ; designs ecu hardware circuit based on mcu , including ecu input and output signal processing channel , and the emigration of c / os embedded real time operating system on mcu lpc2292 ; designs fuel injection control project software procedure , and simulate it . it implements the open loop control of air fuel ratio under part of the motor working condition
  在充分进行可行性论证的基础上,完善了ecu的硬件设计总体方案;设计了基于单片机的ecu硬件单元电路,包括ecu的输入、输出信号处理通道以及c / os嵌入式实时操作系统在lpc2292单片机上的移植;设计了燃油喷射控制项目的软件流程;最后通过模拟仿真,实现了发动机部分工况下的空燃比的开环控制目标。