钳位的英文

• circuitry, clamping
• clamper
• clamping circuitry
• diode clamping
• tong space

• "钳"英文翻译    pincers; pliers; tongs
• "位"英文翻译    place; location
• "钳位管" 英文翻译 :    clamper tube
• "软钳位" 英文翻译 :    soft clamping
• "钳位电路；钳位器" 英文翻译 :    clamper
• "单向钳位" 英文翻译 :    unidirectional clamp
• "电平钳位" 英文翻译 :    clamping
• "电压钳位" 英文翻译 :    voltage clamp
• "电压钳位法" 英文翻译 :    voltage clamp method
• "动钳位移" 英文翻译 :    sliding distance of moving clamps
• "动态钳位" 英文翻译 :    dynamic clamp
• "反向钳位" 英文翻译 :    back clamping
• "接线板；钳位器" 英文翻译 :    clamper
• "开关钳位器" 英文翻译 :    switching clamper
• "逻辑钳位" 英文翻译 :    logic clamp
• "钳位电流" 英文翻译 :    clamp current; current, clamp
• "钳位电路" 英文翻译 :    circuitry, clamping; cladding circuit; clamper; clamping circuitry
• "钳位电平" 英文翻译 :    block level; clamlevel; clamping level
• "钳位电压" 英文翻译 :    clamvoltage
• "钳位电阻" 英文翻译 :    clamresistance
• "钳位二极管" 英文翻译 :    clamdiode; clamping diode
• "钳位放大器" 英文翻译 :    clamped amplifier
• "钳位脉冲" 英文翻译 :    clamp pulse; clamping pulse
• "钳位偏压" 英文翻译 :    clamp bias
• "钳位时间" 英文翻译 :    clamping interval

• Simulation study of diode clamping threc - level inverter
  二极管钳位三电平逆变器的仿真研究
• Double clamping brush - holders for electrical machinery ; principal dimensions
  电动机用双钳位刷握器.第1部分:主要尺寸
• Clamping diode circuit
  钳位二极管电路
• Clamp keying pulse
  钳位键控脉冲
• An actively clamped low ripple resonant dc link inverter with medium power is introduced
  摘要介绍了一种中等容量有源钳位谐振直流环节逆变器。
• A clamp is used in some data sets to hold receiver output constant and avoid troublesome noise interference when no data signals are being received
  钳位电路用于某些数据设备可使接收器输出为常量,并且可在没有收到数据信号时避免噪音干扰。
• For this , conventional clamping straps are replaced by so - called tension measuring straps with an integrated sensor - amplifier unit , made by tecsis
  因为传统的钳位带已经被称为拉力测量带所取代，其中的内置传感器放大器单元就是由tecsis制造的。
• On the base of introducing basic application technologies , the paper studies the boost - flyback single - stage isolated pfc converter with active clamping and soft switching emphatic ~ . lly
  在介绍了基本应用技术的基础上，论文对带有源钳位和软开关的升压型反激式单级pfc变换器做了重点研究。
• Through instance and analyzing concrete data , the two ways of measuring insulation are introduced . the implementation of the method of clamping rundle circuit and its capability are described emphatically
  通过对实例和具体数据的分析，介绍了2种测量绝缘的方法，重点讲述了钳位电路梯级测量法的实现及其性能
• Ac small signal model and the operating principle of forward converter with active clamp are analyzed in this paper . the superiority of fac is obtained by comparing three typical kinds of methods of magnetic reset for forward converters
  本文结合应用有源钳位正激变换器，对有源钳位正激变换器从电路的工作模式到小信号模型建立进行了深入的分析。