降低温度的英文

• reduced temperature

• "降低"英文翻译    reduce; cut down; abate; deb ...
• "温度"英文翻译    temperature
• "低温度" 英文翻译 :    cryogenic temperature; low temperature
• "温度的降低" 英文翻译 :    a decrease in temperature
• "温度降低" 英文翻译 :    fall of temperature; reduction of temperature; temperature reduction
• "低温温度" 英文翻译 :    cryogenic temperature
• "低温温度表" 英文翻译 :    katathermometer
• "低温温度计" 英文翻译 :    cryogenic thermometer; cryometer; katathermometer; low reading thermometer; low temperature thermometer; low-reading thermometer; low-temperature thermometer
• "极低温度" 英文翻译 :    very low temperature
• "日最低温度" 英文翻译 :    daily minimum temperature
• "月最低温度" 英文翻译 :    monthly minimum temperature
• "最低温度" 英文翻译 :    lowest temperature; minimum temperature; minimumtemperature; nadir
• "最低温度表" 英文翻译 :    minimum thermometer
• "最低温度计" 英文翻译 :    minimum thermoimeter; minimum thermometer; minimumthermometer
• "降低(温度等)；使倒下" 英文翻译 :    bring down
• "皮肤温度降低" 英文翻译 :    decreased skin temperature
• "夜间温度降低" 英文翻译 :    night setback
• "极端最低温度" 英文翻译 :    extreme maximum temperature; extreme minimum temperature
• "生存最低温度" 英文翻译 :    minimum survival temperature
• "生物最低温度" 英文翻译 :    biological minima temperature
• "最低温度50度" 英文翻译 :    minimum: temperature min
• "低温度系数电阻器" 英文翻译 :    low temperature coefficient resistor
• "低温蒸馏温度计" 英文翻译 :    low distillation thermometer; low distillation thermometre
• "深冷温度计，低温计" 英文翻译 :    cryometer
• "生物学最低温度" 英文翻译 :    biological minimum temperature

• Shorten melt residence time and melt temperature
  缩短熔化驻留时间和降低温度
• Raising temperature enhanced the activities of bkca channels , meanwhile decreased temperature had opposite change
  （二）升高温度增强该通道的活性，降低温度则使其活性减弱。
• When the alioa content is increasing , the hardness of composites are also increasing and the temperature at which the hardness obviously reducing are increasing too
  随着aizo 。含量的提高，复合材料的硬度越高，高温退火后的硬度明显降低温度点也越高。
• 5 . after high temperature annealing the hardness of the composites did not reduced obviously until 973k , this temperature greatly exceeds that of pure copper ( after cold machining , the temperature is 423k )
  本文制备的材料经高温退火后的硬度明显降低温度点为973k ，大大超过了纯铜（冷加工态）的423k ，而且热稳定性能较好。
• The paper studies the mechanism of the monitoring system and gives it ' s structure . considering the practice , the software is compiled which is based on win98 dll and used to control the sample and disposing data
  提出了微水含量在线监测系统的工作原理及实施方案，设计了系统的整体硬件结构以提高测量的准确度和稳定度并降低温度的影响和杂散干扰。
• The experiment result shows that the operating conditions have a significant effect upon the chromium content , and it increased with the raise of current density and ph value , but decrease with the temperature raise of the bath
  温度、 ph值、阴极电流密度对镀层中铬含量的影响较大。试验结果表明：降低温度、提高ph值和阴极电流密度有利于提高镀层的含铬量。
• Of the currently available coolers for electronic products with a high heat flux , microchannel heat sinks have been proved to be able to provide the best heat transfer performance and are one of the most promising coolers . the manifold microchannel ( mmc ) heat sink has many advantages such as low thermal resistance , compact structure , little amount of coolant , low flow rate , uniform temperature distribution along the flow direction and many others , so it is able to provide the best heat transfer performance : lowering the maxmal temperature and the temperature difference
  在目前高热通量电子产品冷却器中,微通道热沉已被证实是传热性能最佳且最具应用潜力的冷却方式之一,而歧管式微通道热沉因具有低热阻、结构紧凑、所需冷却液量小、沿流动方向温度分布均匀等优点则成为减小电子元器件换热表面最高温度、降低温度变化的一种有效方法。
• Various attempts have been made to study the effect of electrochemical polymerization processes including temperature , electrolyte composition and the deposited location on the strength and brittle - tough properties . by the mechanical measurement and testing , we found , compared with the mixed electrolyte composition of isopropyl alcohol ( ipa ) + 5 % boron trifluoride diethyl etherate ( bfee ) + 5 % polyethylene glycol ( peg ) , the better mechanical properties of conducting ppy films were given by the mixed electrolyte compositon of ipa + 5 % bfee + 5 % deg
  结果发现，当添加剂peg的浓度不变时，改变bfee的浓度可以改变薄膜材料的性能，其中以30的bfee浓度为最佳；当固定电解液中bfee浓度不变时，改变添加剂的浓度对制备的薄膜性能参数影响不明显，但以peg100为临界；降低温度，可以使薄膜生长减缓，有利于得到性能更好的薄膜。