tension-torsion中文是什么意思

• 拉、扭剪

• "tension"中文翻译    n. 1.拉紧；伸张。 2.(精神、局势等)紧张。 3. ...
• "torsion"中文翻译    n. 扭转；扭(转)力；【物理学】扭(力)矩，转(力)矩 ...
• "torsion bar spring tension" 中文翻译 :    扭杆弹簧扭转
• "torsion" 中文翻译 :    n. 扭转；扭(转)力；【物理学】扭(力)矩，转(力)矩；【医学】捩转。 torsion pairing 扭曲配对。
• "tension" 中文翻译 :    n. 1.拉紧；伸张。 2.(精神、局势等)紧张。 3.【物理学】张力，拉力，牵力；(弹性体的)应力；(蒸气等的)膨胀力，压力。 4.【电学】电压，拉伸力，拉紧[绷紧]装置，绷子。 create [ease, reduce] the international tension 制造[缓和]国际紧张局势。 reduce [relieve] the tension of the market 缓和市场紧张情况。 T- runs high. 形势极为紧张。 surface tension 表面张力。 vapor tension 蒸气张力。 a high tension current 高压电流。 tension failure 伸张破坏。 vt. 张紧，使紧张。 adj. -al
• "aeroelastic torsion" 中文翻译 :    气动弹性扭转
• "affine torsion" 中文翻译 :    仿射挠率
• "alternating torsion" 中文翻译 :    交变扭转
• "angle of torsion" 中文翻译 :    挠率角; 扭角; 扭转角度; 终极稳定角
• "antidromal torsion" 中文翻译 :    异向扭转
• "cecal torsion" 中文翻译 :    盲肠扭转
• "center of torsion" 中文翻译 :    扭转中心
• "coefficient of torsion" 中文翻译 :    扭力系数; 扭曲系数; 扭转系数; 捩转系数
• "conformal torsion" 中文翻译 :    保形挠率
• "crust torsion" 中文翻译 :    地壳扭动; 地壳扭力
• "degree of torsion" 中文翻译 :    扭转度
• "elastic torsion" 中文翻译 :    弹性扭力
• "elasticity of torsion" 中文翻译 :    扭转弹性
• "elastoplastic torsion" 中文翻译 :    弹塑性扭转
• "failure in torsion" 中文翻译 :    扭曲破损
• "first torsion" 中文翻译 :    一阶扭转
• "flexion torsion" 中文翻译 :    弯曲扭转
• "flexure torsion" 中文翻译 :    挠曲扭转
• "free torsion" 中文翻译 :    自由扭转
• "fusional torsion" 中文翻译 :    融合性扭转

• Using newly developed filament - wound composite tubular specimens , the tension - torsion biaxial loading fatigue tests were performed
  同时设计出一种缠绕复合材料管状试样，进行了拉扭双轴疲劳实验研究。
• It is not yet very known especially of the mechanical behaviour after secondary hardening such as torsion - tension - tension and tension - torsion - tension
  特别是在扭转-拉伸-拉伸和拉伸-扭转-拉伸等二次硬化后的a3钢的力学性能还不甚了解。
• The mechanical behaviour of a3 steel specimen under monotonic tension , pure torsion , torsion - tension , tension - torsion , torsion - tension - tension , tension - torsion - tension were studied by standard cylinder specimen in this paper
  本文研究了a3钢试件在单一拉伸、纯扭转时的力学性能；在拉伸-扭转、扭转-拉伸时的力学性能；在扭转-拉伸-拉伸、拉伸-扭转-拉伸时的力学性能。
• Comparing with these several strengthen formal , towards strength limit ' s improvement , the effect of torsion - tension and tension - torsion - tension was close ; simply tension - torsion - tension required a little larger prestrain quantity . whereas , towards yield limit " s improvement , the effect of torsion - tension - tension action ' s strengthen was the best
  从几种硬化形式的比较来看，对于强度极限的提高，扭转-拉伸和拉伸-扭转-拉伸的强化效果相近，只是拉伸-扭转-拉伸所需的预应变量要大一些；而对于屈服极限的提高，扭转-拉伸-拉伸作用下的强化效果最佳。
• When the a3 steel specimen was operated by tension - torsion - tension action , both the yield limit and strength limit had very large improved compared with that of monotonic tension . the improve scope of the yield limit could be 109 . 36 % , the strength limit could be 56 . 26 % . the yield limit value reached the max
  A3钢试件在拉伸-扭转-拉伸作用下的力学性能与单一拉伸相比，试件的屈服极限和强度极限都有很大提高。屈服极限提高幅度最高可达109 . 36 ，强度极限提高幅度最高可达56 . 26 。
• After pretorsion the successor tensile yield limit and strength limit both improved very highly , but the trend of the increase of the strength limit was suspended till the pretorsional capacity reached 17 , when the pretorsional capacity was greater than17 ( prestrain value was 81 . 19 % of total strain ) , the successor strength limit rapid failed and approached the yield limit . this illustrate the a3 steel specimen translate from plasticity into friability after pretorsion strengthen . when the specimen was operated by tension - torsion action , the yield limit had very large improved , but the strength limit changed very little . furthermore , the trend of the increase of the strength limit was suspended till the pretension capacity reached 0 . 25 ( prestrain value was 66 . 93 % of total strain )
  A3钢试件在预扭转后，后继拉伸屈服极限和强度极限均有很大提高，但强度极限的增大趋势到预扭转量为17为止，预扭转量大于17 (预应变值为总应变的81 . 19 )后强度极限迅速下降，与其屈服极限接近，这说明a3钢试件经预扭转强化后逐渐由塑性转化为脆性。该预应变值为a3钢试件的韧脆转变点。 a3钢试件在拉伸-扭转作用下，屈服极限有很大提高，但强度极限没有多大改变，而且，屈服极限的增大趋势到预拉伸量为0 . 25应变(预应变量为总应变量的66 . 93 )后就不再增加。
• Consider the total plasticity of these several kinds of prestrain a3 steel specimen . the total plasticity of tension - torsion - tension action was higher than that of torsion - tension and torsion - tension - tension action . but the max . values of their total plasticity were all greater than those of any single destructional form
  考虑几种预应变下的a3钢试件的总塑性，拉伸-扭转-拉伸作用下的总塑性比扭转-拉伸和扭转-拉伸-拉伸作用下的总塑性有明显的提高。但它们的总塑性的最大值都大于单一破坏形式下的总塑性。