再结晶退火的英文

• recrystallization annealing
• recrystallizational annealing

• "再结晶"英文翻译    recrystallization
• "退火"英文翻译    anneal; annealing; back-out
• "退火再结晶" 英文翻译 :    annealing recrystallization
• "再结晶" 英文翻译 :    [冶金学] recrystallization 再结晶良好 well-recry-stallized
• "初级再结晶" 英文翻译 :    primary recrystallization
• "等温再结晶" 英文翻译 :    isothermal recrystalization
• "动态再结晶" 英文翻译 :    drx; dynamic recrystallization
• "二次再结晶" 英文翻译 :    secondary recrystallization
• "反差再结晶" 英文翻译 :    abnormal recrystallization
• "晶间再结晶" 英文翻译 :    intercrystalline recrystallization; intercrystallinerecrystallization
• "聚集再结晶" 英文翻译 :    collective recrystallization
• "区域再结晶" 英文翻译 :    zone recrystallization
• "三次再结晶" 英文翻译 :    tertiary recrystallization
• "衰退再结晶" 英文翻译 :    degenerative recrystallization
• "一次再结晶" 英文翻译 :    primary recrystallization; primaryrecrystallization
• "优先再结晶" 英文翻译 :    selective recrystallization
• "再结晶边界" 英文翻译 :    recrystallization boundary
• "再结晶变形" 英文翻译 :    paracrystalline deformation
• "再结晶层" 英文翻译 :    recrystallized layer
• "再结晶程度" 英文翻译 :    degree of recrystalization
• "再结晶的" 英文翻译 :    blastic; recrystallized
• "再结晶阀值" 英文翻译 :    recrystallized threshold
• "再结晶钢" 英文翻译 :    reacting steel
• "再结晶焊接" 英文翻译 :    recrystallization welding
• "再结晶核" 英文翻译 :    recrystallization nucleus

• A satificatory effect is obtained by rime annealing
  采用再结晶退火工艺处理，可取得满意效果。
• The formation of a new set of strain - free grains within a previously cold - worked material ; normally an annealing heat treatment is necessary
  在冷塑性变形材料的内部生成等轴状新晶粒的过程叫再结晶，通常发生于再结晶退火热处理过程中。
• Low cycle fatigue ( lcf ) behavior of zircaloy - 4 has been reviewed in the present paper . then , the lcf behavior of a recrystallized zircaloy - 4 plate with different texture has been studied at room temperature and 400 , respectively
  并在此基础上，研究了不同温度(室温和400 ) 、不同取向(平行于轧向和垂直于轧向)的再结晶退火态zr - 4合金板材试样的低周疲劳性能。
• Zircaloy - 4 sheet , which was cold - worked followed by recrystallization annealing , exhibits longer lcf life in the rolling direction than that in the transverse direction , and the fact that difference in lcf life between both directions becomes larger as the range of plastic strain becomes lower can be attributed to the texture effect , p - solution treatment deteriorates the alloy ' s lcf property because the treatment lowers the average value of alloy ' s schmid factors , and the subsequent annealing - treatment in a - phase range has a impact on the lcf properties , i . e . the subsequent annealing - treatment at 500 ? for 1 . 5h results in better property than that at 750 for 1 . 5h , which comes mainly from the fact that the alloy annealled at 500 for 1 . 5h has lower amount of the precipitate particles than the alloy annealled at 750 for 1 . 5h
  对于冷加工后经再结晶退火处理的zr - 4合金，轧制方向的低周疲劳寿命比横向要大。随着_ p的降低，两个方向的低周疲劳寿命的差别相应增加，这是由于合金中存在织构的缘故。冷加工后经再结晶退火处理的zr - 4合金在固溶处理后，抗疲劳性能明显降低，这主要是由于固溶处理降低了合金的schmid因子；固溶处理后在相区的退火对疲劳性能有影响，即500 1 . 5h退火的抗疲劳性能要优于750 1 . 5h退火，这主要与500 1 . 5h退火的合金中沉淀相粒子的数量较少有关。
• The alloys , which were cold - worked followed by recrystallization annealing , display cyclic softening in the range of low strain because the cyclic stress - strain curve lies below the monotonic stress - strain curve , and show cyclic hardening in the range of high strain because the cyclic stress - strain curve lies above the monotonic stress - strain curve
  在低应变范围，冷加工后经再结晶退火处理的错合金的循环应力一应变曲线位于单调拉伸曲线的下方，表现为循环软化;在高应变范围则位于单调拉伸曲线的上方，表现为循环硬化。

• 再结晶退火的日语：さいけっしょうやきなまし