氧化温度的英文

• oxidation temperature
• oxidizing temperature

• "氧化"英文翻译    oxidize; oxidate; oxide; bur ...
• "温度"英文翻译    temperature
• "再氧化温度" 英文翻译 :    re oxidation temperature
• "玻璃化温度" 英文翻译 :    glass state temperature; glass temperature; glass transition temperature
• "脆化温度" 英文翻译 :    brittle temperature; brittleness(brittle) temperature; embrittlement temperature
• "固化温度" 英文翻译 :    curing temperature; temperature
• "灰熔化温度" 英文翻译 :    ash fusion point
• "活化温度" 英文翻译 :    activation temperature
• "简化温度" 英文翻译 :    reduced temperature
• "金属化温度" 英文翻译 :    metallizing temperature
• "晶核化温度" 英文翻译 :    germinative temperature
• "晶粒化温度" 英文翻译 :    grain coarsening temperature
• "均化温度" 英文翻译 :    homogenization temperature
• "均一化温度" 英文翻译 :    homogenization temperature
• "宽硫化温度" 英文翻译 :    broad range of cure
• "老化温度" 英文翻译 :    aging temperature; burn-in temperature
• "裂化温度" 英文翻译 :    cracking temperature
• "硫化温度" 英文翻译 :    cure temperature; curing temperature
• "氯化温度" 英文翻译 :    chlorination temperature
• "敏化温度" 英文翻译 :    sensitizing temperature
• "汽化温度" 英文翻译 :    steaming temperature; vaporization temperature; vapourizing temperature
• "氢氟化温度" 英文翻译 :    hydrofluorination temperature
• "氰化温度" 英文翻译 :    cyaniding temperature
• "热纯化温度" 英文翻译 :    thermal inactivation temperature
• "热裂化温度" 英文翻译 :    thermal cracking temperature

• Lodometry method was used to measure the content of the hydroperoxide groups on the membrane surface
  采用碘量法测定了plla膜表面大分子过氧化氢基团的浓度，并考察了氧化时间和氧化温度的影响。
• The starting oxidation temperature of copper powders prepared by hydrothermal method is about 210 and average particle size is about 0 . 7 m
  采用此参数可得到平均粒度为0 . 7 m ,分布狭窄,开始氧化温度约为210的超细铜粉。
• Anti - oxidation temperature of diamond with 500 ppm boron reached 1070 specific resistance of diamond with 2158 ppm boron was 1 . 93 cm
  含硼500ppm的金刚石抗氧化温度提高到1070 。当含硼量为2158ppm时金刚石的电阻率为1 . 93 ? cm 。
• The content of the hydroperoxide groups on the photooxidized plla membrane surface increased initially and then decreased with the photooxidization time
  随氧化时间延长，大分子过氧化氢基团的浓度先升后降。氧化温度升高能够加快氧化过程的进行。
• The model of primary battery theory was built to explain the mechanism of improving uniformity of copper powders . as the two different particles closing up , primary battery reaction happened because of the
  使原来存在大量扭折、台阶等缺陷的铜晶得到晶格修补,使晶格完美化生长,从而一定程度上提高了其抗氧化温度。
• The optimized experiments were used to explore the optimal hydrothermal conditions in order to prepare cu powders which have excellent properties . the optimal parameters of hydrothermal experiment as follows : the temperature is 240 , the time of reaction is 10h and the volume ratio of solution filling is 80 %
  将粒度均匀性和开始氧化温度作为衡量铜粉性能的指标,最终得到的最佳工艺参数为:水热温度为240 ,反应时间为10h ,溶液填充度为80 % 。
• The factors affecting the formation of self - healing anti - oxidation protective layer include relative density of the composites , the content of sic and b4c , the ratio value of sic / b4c and oxidation temperature etc . , and the effect of sintering process on the enhancement of density of composites and then on the enhancement of anti - oxidation property is especially emphasized
  能否生成自愈合抗氧化保护膜的影响因素有材料的相对密度、 b _ 4c含量、 sic b _ 4c含量比值、氧化温度等，并强调了烧结过程对提高复合材料密度进而提高抗氧化性能的作用。
• But the grain growth , grain semiconduction and grain boundary insulation were influenced by many factors , such as the type and contents of dopants , sintering temperature and so on . therefore , in this thesis the effect of the restore sintering temperature , the oxygenize temperature , the donor and acceptor dopant on the dielectric and varistor properties of devices were studied . with sem , the microstructure of srtio3 - based double function ceramic was analyzed
  而晶粒生长、晶粒半导化和晶界绝缘化受到多种因素的影响，诸如杂质的种类和含量、烧成温度等，因此本论文研究了还原烧成温度、中温氧化温度、施主和受主掺杂等对srtio _ 3基陶瓷的压敏和介电性能的影响，并借助于sem分析对srtio _ 3基双功能陶瓷的微观结构进行了分析。
• In order to make investigators know about the current research state of preparation of the carbon / graphite materials with high density and strength from mesocarbon microbeads , and direct the research , development and production , in this review , the influence of preparaed mesocarbon microbeads from various raw materials and methods of preparation , ball diameter of carbosphere , preoxidation temperature and time , moulding pressure and time , heat treatment temperature and heating rate , holding time on the mechanical properties and microscopic structure of carbon / graphite product were discussed by us
  摘要为了对中间相炭微球制备高密高强炭石墨材料的研究现状有所了解，并且对实验和实际生产起到指导作用，本文通过参阅大量中外文献，讨论了不同原料及制备方法制得的中间相炭微球、炭微球的球径、预氧化温度及时间、成型压力及时间、热处理温度及升温速率、保温时间对炭石墨制品的力学性能及微观结构的影响。
• One - step synthesization made the electrical properties more stable , controling the reducing sintering temperature and retention time can adjust the electrical properties in a certain scope , changing the oxidation temperature made the varistor ’ s voltage v10ma changed , using the special double - layer silver plasm can eliminate the voltage - direction problem
  一次配料得到的样品电性能一致性更好;控制还原气氛烧结温度和保温时间,可以在一定范围内调节钛酸锶压敏电阻器的电性能,改变氧化温度可以获得不同的压敏电压,从而得到系列化产品;采用双层银浆工艺成功消除了压敏电压的方向性问题。