法向速度的英文

• normal velocity

• "法向"英文翻译    normal; heave
• "速度"英文翻译    velocity; speed; blast; bat
• "法向速度分布" 英文翻译 :    normal velocity distribution
• "法向速度分量" 英文翻译 :    normal velocity component
• "径向速度视向速度" 英文翻译 :    radial velocity
• "反向速度" 英文翻译 :    inverse rate
• "横向速度" 英文翻译 :    cross speed; lateral quickness; lateral velocity; tra verse velocity; transverse velocity; transversevelocity
• "径向速度" 英文翻译 :    radial speed; radial velocity
• "切向速度" 英文翻译 :    tangential eed; tangential speed; tangential velocity; velocity, tangential
• "切向速度（率）" 英文翻译 :    tangential speed
• "视向速度" 英文翻译 :    line-of-sight velocity; radial velocity; sight line velocity
• "视向速度仪" 英文翻译 :    radial velocity spectrometer
• "竖向速度" 英文翻译 :    vertical velocity
• "线向速度" 英文翻译 :    velocity， linear
• "轴向速度" 英文翻译 :    axial directed velocity; axial velocity; axially directed velocity
• "轴向速度比" 英文翻译 :    axial velocity ratio
• "转向速度" 英文翻译 :    turning velocity
• "纵向速度" 英文翻译 :    longitudinal velocity
• "径向速度；【天文学】视向速度。" 英文翻译 :    radial velocity
• "法向[正交]加速度。" 英文翻译 :    normal acceleration
• "法向分速度" 英文翻译 :    normal velocity component
• "法向加速度" 英文翻译 :    acceleration normal; normal acceleration
• "不等切向速度" 英文翻译 :    unequal tangential velocity
• "垂直方向速度" 英文翻译 :    vertical speed
• "方向速度分量" 英文翻译 :    x-velocity component ==

• Finally , we propose the third mirror scheme to reflect atomic by using a blue - detuned semi - flattened - gaussian beam ( sfgb )
  显然，采用半束兰失谐椭圆高斯光束作为原子反射镜，在相同的反射镜面积下，可比sgb反射镜反射更高法向速度的入射原子束。
• The paper has improved the existing lifting - line and lifting - surface design method by including the rake and skew and solving the optimum circulation distribution with the optimum theory . the blade geometry is expressed with b - spline for the lift - surface method . the boundary condition on the blade is transformed to minimize the summation of the square of normal velocities , the fair blade geometry can be obtained by present technique and the design quality is better
  改进了现有的升力线和升力面设计方法，在升力线设计中计及桨叶的纵倾和侧斜的影响，用优化理论求解最佳环量分布，升力面设计中用b样条来拟合桨叶，将物面边界条件转化为求法向速度分量的平方最小，由此可得到光顺的桨叶几何形状，提高和改进了设计质量。
• On the base of milling ball interaction during milling process , the powder height of each collision can be calculated . if the impact of milling ball takes as hertz elastic collision , the maximum real strain and the maximum tangential strain are obtained as follows , e , . . , ln [ h , / ( h0 ? vrcos6 / 2 ) ] = vrsin6 / h0 ? / q , t2rt2 / 2om ~ h , j where s , , p , v are maximum real strain , the maximum tangential strain , friction coefficient and the velocity of milling ball
  对球磨过程中磨球相互作用作了一些假设后，可以计算出每次碰撞所获得粉末体高度值；将磨球的碰撞作为hertz弹性碰撞，碰撞时的速度分解为法向速度和切向速度得出粉末的最大真应变和最大切应变为湖南大学材料物理与化学专业硕士论文r 。
• Our study shows that the optical potential of the diffracted light of the semi - gaussian beam is far higher than that of the evanescent - light wave , and its maximum normal velocity of the incident atoms can be far grater than that of the evanescent - light wave under the same parameters , so the blue - detuned semi - gaussian beam , as a novel atomic mirror , can be used to efficiently reflect atoms with a normal velocity of greater than 1 m / s
  研究表明，半束兰失谐高斯光束衍射光场的光学势远大于消逝波光场的光学势，在同样的参数条件下，入射原子的最大速度也比消逝波光场的大，所以作为一种新颖的原子反射镜，半束兰失谐高斯光束可以被用来有效的法向速度大于1m s的入射原子。