等距点的英文

• equidistant points

• "等距"英文翻译    equidistance; isometry
• "点"英文翻译    drop
• "等距" 英文翻译 :    equidistance; isometry
• "分距点" 英文翻译 :    fraction distance point
• "跨距点" 英文翻译 :    ski oint; skipoint; span point
• "视距点" 英文翻译 :    stadia point
• "准距点" 英文翻译 :    anallatic point
• "准距点播机" 英文翻译 :    seed spacing drill
• "最大圈距点" 英文翻译 :    maximum turn separation point
• "准距点，准距中心" 英文翻译 :    anallatic center
• "等距；等高" 英文翻译 :    isometry
• "等距的" 英文翻译 :    aequidistant equidistant; equal-spaced; equally spaced; equally spsced; equally-spaced; equilong; equispaced; isometrical; length-preserving
• "等距法" 英文翻译 :    method of equal intervals
• "等距孔" 英文翻译 :    equispaced holes
• "等距离" 英文翻译 :    equidistance◇等距离外交 equidistant diplomacy
• "等距码" 英文翻译 :    equidistant code
• "等距平" 英文翻译 :    equideparture
• "等距图" 英文翻译 :    isometric chart; isometric drawing; isometric stereogram
• "等距线" 英文翻译 :    equal space line; equal-space line; equidistant lines; line of equidistance
• "等距圆" 英文翻译 :    isometric circle
• "等距轴" 英文翻译 :    isometric axis
• "等间距 等距离 等距离的" 英文翻译 :    equidistant
• "不等距轮齿" 英文翻译 :    uneaually spaced tooth; unequally spaced teeth
• "不等距螺杆" 英文翻译 :    non-constant lead screw
• "不等距区间" 英文翻译 :    unequally spaced intervals

• Equidistant interpolation can give rise to convergence difficulties when the number of interpolation points becomes large . this difficulty is often referred to as runge ' s phenomenon
  等距点插值会带来收敛困难当插值点数量增加。这一困难被称为龙格现象。
• In shadow moir topography , there are theoretically four main kinds of optical field arrangements as parallel illumination and parallel receiving , parallel illumination and point receiving , point illumination and point receiving with equal distance , point illumination and point receiving with unequal distance
  摘要形貌影栅云纹测量中主要有4种光场：平行照射平行观察、平行照射点观察、等距点照射点观察和不等距点照射点观察光场。
• The general idea behind the second one is approximation . the control mesh is subdivided until the error between the control vertices and corresponding subdivision surface is less than a given threshold . then the vertices substitute those points on the surface approximately . the last step is to calculate offset point for every vertex and connect them to form an offset surface
  第二种算法采用逼近思想，首先通过对控制网格进行细分，当控制顶点和细分曲面的距离满足一定误差要求时，近似用控制顶点代替细分曲面上的点，然后对各个顶点分别求等距点。