繁體版 English
登录 注册

蚀程度的英文

发音:  
"蚀程度"怎么读用"蚀程度"造句

英文翻译手机手机版

  • degree of corrosion

例句与用法

  • In newly - constructed stage , early stage and later stage of reclamation , the degree of erosion and the space - time characteristics of influence factors have been analyzed and compared by the evaluation index and model
    运用评价指标和模型分析了排土场未复垦时期、复垦初期、复垦后期的土壤水蚀程度及影响因子的时空变化特征
  • Aramid filaments are treated by a low - temperature plasma with different treatment times . the surface of filaments is observed by sem and the results show that the filament surface is smooth before the treatment and becomes more rough if filaments are treated for 6 minutes . in addition , it is found that the filament peels after 9 minutes of plasma treatment
    本课题采用低温等离子体对芳纶纤维进行表面处理后,用sem观察纤维表面,发现未经等离子体处理的纤维表面比较光滑;等离子体处理6分钟后,纤维表面变得粗糙,产生很多微小的刻蚀坑;等离子体处理9分钟后,纤维表面受到的刻蚀程度明显增加,并产生表面剥离现象。
  • The studies expressed that the tensile - strength declined with the growth of dose rate after the radiation treatment , and at the same time , the gel content had extreme value with the change of the dose rate . the surface of uhmwpe fibers showed some irregular micro - pits and dents after radiation treatment , narnely rough degree increasing . their number and deepness increased with increase of dose . and this phenomenon is the most obvious when the dose rate was 8 . 5kgy / s and the dose was 400kgy . at the same time some containing oxygen groups , including hydroxyl group , carbonyl group and carboxyl group , were introduced into the fiber surface which was exposed to the air
    研究表明, uhmwpe纤维经电子束辐照处理后,纤维的拉伸断裂强度随剂量率的增加呈下降趋势,凝胶含量随着剂量率的变化存在极值。纤维表面出现了不规则的微裂纹和凹痕,随着剂量的增大,电子束对纤维表面的刻蚀程度增加,在本研究中以剂量为400kgy剂量率为8 . 5kgy s时刻蚀效应最为明显。同时,在空气中进行辐照时,纤维表面被引入了一些含氧基团,包括羟基、羰基和羧基。
用"蚀程度"造句  
蚀程度的英文翻译,蚀程度英文怎么说,怎么用英语翻译蚀程度,蚀程度的英文意思,蝕程度的英文蚀程度 meaning in English蝕程度的英文蚀程度怎么读,发音,例句,用法和解释由查查在线词典提供,版权所有违者必究。