长冲程的英文

• long stroke

• "长"英文翻译    older; elder; senior
• "冲程"英文翻译    travel; stroke; 4
• "长冲程泵" 英文翻译 :    long-stroke pump
• "长冲程冲头" 英文翻译 :    long-stroke punch
• "超长冲程" 英文翻译 :    ultra long stroke
• "长冲程柴油机" 英文翻译 :    long stroke engine; long-stroke diesel engine
• "长冲程抽油机" 英文翻译 :    long stroke pumping unit
• "长冲程发动机" 英文翻译 :    engine long stroke; undersquare engine
• "长冲程水压机" 英文翻译 :    long-stroke press
• "长冲程震击器" 英文翻译 :    long strke bumper sub
• "长冲程蒸汽机" 英文翻译 :    long-stroke steam engine
• "长冲程减震支柱" 英文翻译 :    long-stroke strut
• "超长冲程柴油机" 英文翻译 :    super-long stroke diesel engine; ultra long stroke diesel
• "超长冲程低速船用柴油机" 英文翻译 :    ultra long stroke low speed marine diesel engine
• "长冲" 英文翻译 :    nagaoki
• "冲程" 英文翻译 :    [机械工程] travel; (length of) stroke: 4 冲程发动机 four-stroke engine
• "长冲击钎子" 英文翻译 :    long jumper
• "泵冲程" 英文翻译 :    pump stroke; pumstroke carrea de golpe; throw of pump
• "冲程；振幅" 英文翻译 :    stroke
• "冲程顶" 英文翻译 :    top of stroke
• "冲程分" 英文翻译 :    spm
• "冲程数" 英文翻译 :    number of strokes
• "单冲程" 英文翻译 :    single stroke
• "短冲程" 英文翻译 :    short stroke
• "二冲程" 英文翻译 :    two stroke◇二冲程发动机 [机械工程] two-stroke engine; 二冲程内燃机 two-stroke internal combustion engine; 二冲程循环 [机械工程] two-stroke cycle

• A new kind of long stroke wheel style pumping unit
  一种长冲程转轮式抽油机
• The design of chain type long stroke pumping unit
  链式长冲程抽油机设计
• A kind of long - strike oil pumping machine using planet - gear
  一种行星齿轮长冲程抽油机的换向机构研究
• The research on lower super - long stroke pumping unit with a cylinder - chain
  圆柱链低矮式超长冲程抽油机的研究
• Parameter analysis of long stroke pumping units of accurate counterbalance and dual - belt of b - 14 - type
  14型全平衡双带长冲程抽油机参数分析
• Optimum design of a long stroke variable torque pumping unit and simulation of its dynamic behaviors
  扇形长冲程抽油机的优化设计与动力仿真
• The machine program consists of progressive headers , bolt making units , short and long stroke part formers
  其机械范围包括多工位成形机，螺栓成套机，短、长冲程零件成形机。
• The combination of high gear ratio and long stroke can drain an entire air system unless the air supply system is specially designed to accommodate this type of actuator
  除非气源供应系统是经过特殊配置，以满足这种类型执行机构的要求，或者高齿轮传速比和长冲程的组合可能会耗尽整个气源系统。